Estimate the tension in the rope if the wind

Assignment Help Civil Engineering
Reference no: EM13531128

1.The intensity of Na light passing through a gold film wasmeasured to be about 15% of the incoming light. What is thethickness of the gold film? ( λ=589 nm; k=3.2).

2.The large, newly planted tree is kept from tipping over in a windby use of a rope that is tied to a low branch at a 45 degree anglefrom the ground. It is assumed that the sandy soil cannotsupport any moment about the center of the soil ball, point A which is directly below the trunk. the lowest tree branches are 2 mfrom the ground. Estimate the tension in the rope if the wind is 80 km/hr.

Reference no: EM13531128

Questions Cloud

Rewrite the middle term as the sum of two terms and then : Rewrite the middle term as the sum of two terms and then factor completely.
How long does it take light traveling : The distance from a star to a planet is 3.1 * 1019 m.  How long does it take light, traveling at 1016 m/year, to travel from the star to the planet?
Calculate the mass of steam condensed during this process : A room is filled with saturated steam at 100 degrees C. Now a 5-kgbowling ball at 25 degrees C is brought to the room. Heat istransferred to the ball from the steam, and the temperature of the
With this method approximately 80liters of water are require : A meat packing plant manager is trying to decide between twodifferent methods for cooling cooked hams. the spray methodinvolves spraying water over the hams until the ham temperature isreduced to 30 degrees Celcius. With this method approximately 80l..
Estimate the tension in the rope if the wind : The intensity of Na light passing through a gold film wasmeasured to be about 15% of the incoming light. What is thethickness of the gold film? ( λ=589 nm; k=3.2).
What is the original unstretched length of the cable : A 57.0 kg skier is being pulled up a 13.0° slope by a steelcable. The cable has a cross-sectional area of 7.18 10-5 m2. The cable applies a force tothe skier
Determine the approximate drag coefficient for the parachute : A 5-m-diameter parachute of a new design is to be used to transporta load from flight altitude to the ground with an average verticalspeed of 3 m/s. The total weight of the load and theparachute is 200 N. Determine the approximate dragcoefficient for..
Do the same for saturated vapor steam in an adiabatic : Saturated liquid water is in an adiabatic compressor with inlet and outlet pressures of 100 kPa and 1 Mpa. The isentropic efficiency is 85%. Find the work input (kj/kg) and entropy generation (kj/ kg K).Do the same for saturated vapor steam in an adi..
What is the density of the rock before it blasted : You are given the following information about a dry-batchpaving operation. You are going to use one mixer that has a servicerate of 30 serives/hr. The dry-batch trucks you use forbringing concrete to the paver have an arrival rate of 7.5 arrivals/hr...

Reviews

Write a Review

Civil Engineering Questions & Answers

  What are the important findings

What are the important findings in Austin Road Co. v. OSHRC and Builders Steel Co. v. Marshall? Your response should be approximately 200 - 300 words and include a reference citation for your response.

  What is the max length to which it may be stretched

For an unknown alloy the stress at which plastic deformation begins is 400MPa and the modulus of elasticity is 120GPa. If the original specimen length is 76 mm, what is the max length to which it may be stretched without causing plastic deformatio..

  How to complete standardized test is normal random variable

Past experience indicates that the time for high school seniors to complete a standardized test is normal random variable with a mean of 35 minutes.

  Estimate the power required to accelerate a 1350 kg vehicle

The vehicle has a frontal cross -sectional area of 1.9 m^2. The roadway has a straight alignment and a badly patched and broken asphalt surface. assume a drag coefficient of 0.3 and p of air of 1.29 kg/m^3

  Pore water pressure at failure

A CU triaxial test with σc = 20 psi is performed on a sand and a deviator stress of 80 psi fails the specimen. Previous tests revealed that the effective friction angle for this sand is 35°. Calculate the pore water pressure at failure.

  Find what is the minimum radius of curvature for a curve

The coefficient of friction between a car's tires and the road is such that the car can generate a maximum deceleration of 1.1g without experiencing slip.

  What would be the horizontal and vertical component from

what would be the horizontal and vertical component from this acting force see diagram

  Design rectangular duct and fan system to pull 40000 scfm

Design a 2:1 rectangular duct and fan system to pull 40000 scfm of air carrying a medium-density dust through an FCD (Final Control Device) with a P of 6.0 in. H2O.

  Of what industrial use are jominy hardenability curves

(a) Define the hardenability of a steel. (b) Define the hardness of a steel. (c) Describe the Jominy hardenability test. (d) Explain how the data for the plotting of the Jominy curve are obtained and how the curve is constructed.

  Calculate the difference in elevation from a to b

In trigonometric leveling from point A to point B, the slope distance and the zenith angle measured in A were 2504.897 m and 85o08'54". At B, these measurements were 2504.891 m and 94o52'10" respectively.

  Determine the critical point tc and the critical do

If the critical point in a DO sag curve is found to be 18km downstream from the discharge point of untreated wastewater, would you expect the critical point to move upstream (toward the discharge point)

  Determine the diameter of commercial steel pipe required

Determine the diameter of commercial steel pipe required to convey a minimum of 300 cfs of water at 60 deg F with a head loss of 1.2 ft per 1000 ft of pipe. Assume pipes are available in the following nominal diameters (inches)

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd