Estimate the shear stress

Assignment Help Physics
Reference no: EM13263535

A) Estimate the force with which a karate master strikes a board if the hand's speed at time of impact is 13.7 m/s , decreasing to 0.832 m/s during a constant time of 0.00119 s with the board. The mass of coordinated hand and arm is 1.15 kg .

B) Estimate the shear stress if this force is ex- erted on a 0.412 cm -thick pine board that is 13.7 cm wide.

Reference no: EM13263535

Questions Cloud

Design an algorithm in pseudocode to solve the problem : Sizes are given as the diameter of the pizza in inches. The cost of a pizza is based on the size. Bob would like to know which size of pizza has the lowest cost per square inch. a. Identify the inputs and outputs for this problem.
Determine the self-induced emf in the solenoid : A 100 m long solenoid has a radius of 0.050 m and 1.5 x 10^4 turns. Determine the self-induced emf in the solenoid due to the changing environment
What was the most recent dividends per share paid : What was the most recent dividends per share paid on the stock(hint: you are looking for DO)?
What is the cost of retained earnings : A firm's stock is selling for $85. The next annual dividend is expected to be $2.00. The growth rate is 9%. The flotation cost is $5. What is the cost of retained earnings?
Estimate the shear stress : Estimate the shear stress if this force is ex- erted on a 0.412 cm -thick pine board that is 13.7 cm wide
Calculate the amount of charge q in coulombs : A capacitor of value C=10 uF(microfarads: where 1 uF=10^-6 F) has a voltage of 2 volts across it. Calculate the amount of charge Q,in coulombs,on each plate.
What is the expected rate of return on this stock : while the probability of a normal economy is 55% and the chance of a recession is 25%. What is the expected rate of return on this stock?
What is the variance of the returns on rtf : The probability of a boom is 60% while the probability of a recession is 40%. What is the variance of the returns on RTF, Inc. stock?
What is the approximate center frequency of the filter : An SSB generator has a 9 MHz carrier and is used to pass voice frequencies in the 300- to 3300-Hz range. The lower sideband is selected. What is the approximate center frequency of the filter needed to pass the lower sideband.

Reviews

Write a Review

Physics Questions & Answers

  What is the maximum speed of the ball

What is the maximum speed of the ball.

  Find total vector displacement

How numerous years would it take a thermally insulated one-million-kilogram chuck of granite to undergo a 1000k boost in temperature?

  Evaluate to what temperature must both be raised

Evaluate to what temperature must both be raised so that the brass ring will slide onto the rod? If one can cools the assembled system back to 20 celcius, what is teh stress in the brass ring?

  Calculate the magnitude of the lowest energy state

It is possible for a muon to be captured by a proton to form a muonic atom. A muon is identical to an electron except for its mass, Calculate the magnitude of the lowest energy state

  Find frequency of oscillations aroundposition of equilibrium

A homogeneous disk of radius R and mass M rolls without slipping on a horizontal surface and is attracted to a point a distance d below the plane.  find the frequency of oscillations around the position of equilibrium

  What was its speed at the instant it left the table

ball rolls horizontally off the edge of a tabletop that is 1.80 m high. It strikes the floor at a point 1.32 m horizontally away from the table edge. (Neglect air resistance.) (a) How long was the ball in the air? s (b) What was its speed at the i..

  How much power must the motor supply

A small block of mass m = 1.5 kg slides, without friction, along the loop-the-loop track shown. the block starts from the point P a distance h = 54 m above the bottom of the loop of radius R = 17.0 m. What is the kinetic energy of the mass at the ..

  How many electrons are transferred

They are 15.0 m above a fire-fighters safety net. When landing jumper stretches the net 1.0 m before coming to rest. A. what was the average acceleration experienced by the jumper when slowed to rest by the net? B. Is this acceleration positive or ne..

  Determine the magnitude of the emf induced in the rod

A metal rod with a length of 22.0cm lies in the xy-plane and makes an angle of 37.9 degrees with the positive x-axis, What is the magnitude of the emf induced in the rod

  Find the distance point of the blade has traveled in 3 sec

Find the distance point P on the tip of the blade has traveled in 3 sec. Also, find the magnitude of the acceleration of point P when t = 3 sec.

  At what rate is the internal energy of the system changing

A system has a heat source supplying heat at a rate of 187 W and is doing work at a rate of 130.899998 W. At what rate is the internal energy of the system changing.

  Find out the coefficient of kinetic friction

Find out (a) the coefficient of kinetic friction between m2 and the incline, (b) the acceleration of each mass, and (C) the tension in the string.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd