Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Footings for a structure are to be built beneath a basement slab on a clay soil at a depth of 20 ft below present ground level. The groundwater table is 15ft below the ground surface. The soil void-ratio is about 0.087. If the average bearing pressure on the footing is 2,600psf,
A) Estimate the settlement of 10ft and 5ft square footing.
B) What is the factor of safety for the footing in above problem against bearing failure if the clay soil has an unconfined compressive strength of 3,600psf?
What must be the radius of the steel wire if it is to stretch the same distance as the aluminium wire, so that the two wires maintain equal lengths after the masses are attached?
Compute the maximum acceptable service load on an A36 steel plate tension member 1/4in.x12in. having a single line of holes parallel to the direction of loading. The load is 25% dead load and 75% live load, and 7/8in. diameter bolts are used.
The student strikes the sign at a speed of 25 mi/h. if the student was travelling at 65 mi/h when the sign was first spotted, what was the student's associated perception reaction time
Determine the operating speeds of the machine at which the machine's steady-state amplitude is less than 0.2 mm. Take keq = 3 EI/L3.
How to detect eror in line of collimation and what does line of collimation means.
The gate is rectangular with a horizontal width of 2m perpendicular to the paper. For a depth h = 3m of water, calculate the required force exerted by the hydraulic cylinder to keep the gate just closed.
A complete mix activated sludge plant operates at design Q, with the reactor tank volume set by a nominal= 6 hours.. a) It was anticipated that it would operate at 25% RAS for an expected Xr= 2,000 mg/l. What would the actual be
Calculate the largest tolerable internal crack length for a 7075-T651 aluminum alloy component that is loaded to a stress one-half of its yield strength without catastrophic fracture.
The cross sectional dimensions of a 4-ft-long wood member at 30% moisture content is 1.5 in. x 7.5 in., and its weight is 11 lb. At oven-dry condition, its dimensions and weight are 1.35 in x 6.8 in., and 10.2, respectively. What is its specific g..
Air enters an adiabatic nozzle steadily at 300 kPa, 200 o C, and 30 m/s and leaves at 100 kPa and 180 m/s. The inlet area of the nozzle is 80 cm 2 . Determine (a) the mass flow raw through the nozzle, (b) the exit temperature of the air, and (c) the ..
A conical tube of length 8 m fixed vertically with its smaller end upwards. The velocity head and pressure head at upper ends are 1.27 m and 2.50 m respectively. The velocity head and pressure head at lower ends are 0.203 m and 5.407 m respectivel..
design a horizontal curve with a 40-degree central angle ( delta = 40) for a two-lane road with 11-ft lanes. The design speed is 70 mi/h and superelevation is limited to 0.06 ft/ft. Give the radius, degree of curvature, and length of curve that yo..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd