Estimate the power in watts that can be produced

Assignment Help Civil Engineering
Reference no: EM13550417

An Engineer is considering the development of a small wind turbine (D=1.25m) for home applications. The design wind speed is 15 mph at T=10C and p=0.9 bar. The efficiency of the turbine is n=20% meaning that 20% of the kinetic energy in the wind can be extracted. estimate the power in watts that can be produced by the turbine.

Hint: In a time interval delta t, the amount of mass that flows through the rotor is delta m=m(dot)*delta t and the corresponding amount of kinetic energy is this flow is (delta m V^2/2).

Reference no: EM13550417

Questions Cloud

How long will it take for the concentration to be one-quarte : A batch system is assumed to be first order. The initial concentration is 225 mg/L. If the reaction rate constant is 0.65 hr^-1, how long will it take for the concentration to be one-quarter the starting concentration?
Determine the reaction rate constant : A reaction in a batch system is assumed to be first order. Data listed below was collected. Determine the reaction rate constant.
Calculate the mass flux rate and the flow rate : During a drilling operation, the small robotic device is subjected to an (F =) 900 N force at point C as shown. (? = 25°.) Replace this force by an equivalent force-couple system at point O.
What is the deflection of the manometer : A grain-size analysis for a uniform sand in a loose state indicated that the soil particle diameter corresponding to 10% passing on the grain-size distribution curve is 0.18 mm. Estimate the coefficient of permeability.
Estimate the power in watts that can be produced : An Engineer is considering the development of a small wind turbine (D=1.25m) for home applications. The design wind speed is 15 mph at T=10C and p=0.9 bar. The efficiency of the turbine is n=20% meaning that 20% of the kinetic energy in the wind can ..
Determine the soils coefficient of permeability : A constant-head permeability test was conducted on a clean sand sample. The diameter and length of the test specimen were 10.0 and 12.0 respectively. The head difference between manometer levels was 4.9 cm during the test.
Determine the sequent depth : A real estate broker charges a fixed fee of $50 plus a 6% commission on the landowner's profit. If this is uniformly distributed between 0$ and 2000$, find the probability distribution of the brokers total fees.
The total dissolved inorganic carbon of a sample of ground : The total dissolved inorganic carbon (TIC) of a sample of groundwater is 8.33 mM. The temperature of the aquifer is 15C, the pH is 7.5, and the ionic strength is 0.05 M. What is the H2CO3, HCO3-, CO3 2-, and the partial pressure of CO2? [Use activity..
Determine the time average r of the total aerodynamic : An experimental rocket sled weighs 5200 ib abd is propelled by six rocket motors each with an impulse rating of 8600 ib-sec. The rockets are fired at 1 sec intervals, and the duration of each rocket firing is 2sec.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the rate enhancement caused by the enzyme

An uncatalyzed reaction has a rate of 4.2 x 10-7 sec-1. When an enzyme is added the rate is 3.2 x 104 sec-1. Calculate the rate enhancement caused by the enzyme.

  Compute seepage velocity and estimate the hydraulic gradient

A tracer dye is injected into a 55-ft thick sandy gravel confined aquifer which has a hydraulic conductivity of 1.2 x 10^-3 ft/s. The dye appears 14 days later in an observation well 75 ft away from the injection point.

  Determine what would be the relative compaction in the field

The maximum and minimum dry unit weights of a sand were determined in the laboratory to be 104 lb/ft^3 and 93 lb/ft^3, respectively. what would be the relative compaction in the field if the relative density is 78%

  Calculate the length and diameter of the reaction zone

Calculate the length and diameter of the reaction zone of an afterburner that treats 2000 acfm of polluted air (measured at 250 F). The gases in the after burner are at a temperature of 1400 F for a residence time of 0.50 sec.

  Calculate the flow rate in the pipe

Two reservoirs are connected by a pipeline. The pipeline is 1 m in diameter and has a friction factor of 0.03. The elevation difference between the reservoirs is 30 m. The two reservoirs are 5 km apart. The sum of the minor loss coefficients is 34. C..

  Determine the additional tension in each wire

The rigid bar AD is supported by two steel wires of (1/16)" diameter (E=29x10^6 psi) and a pin and bracket at D. Knowing that the wires were initially taut, determine (a) the additional tension in each wire when a 120-lb load P is applied at B

  Please give the numberal value of the following strengths

We have a small wood deck, 8' by 8' This deckshould only have a max of five adults on it. Oneside of deck is attached to the wall of the house, and out fromthis wall is two post six feet from the wall.   Problem is the load bearing strength of the be..

  Determine the change in the bar thickness of axial load

At an axial load of 23 kN, a 40-mm-wide by 10-mm-thick polyimide polymer bar elongates 2.7 mm while the bar width contracts 0.17 mm. The bar is 240 mm long. At the 23-kN load, the stress in the polymer bar is less than its proportional limit.

  Estimate concentration of tba after 10 minutes of oxidation

A groundwater is contaminated with methyl tertiary butyl ether (MTBE) at a concentration of 20 mg/L.the groundwater will be treated with an advanced oxidation process that involves formation of hdyroxyl free radical (OH*).

  Integrate the rate equation and solve for the concentration

Investigators have determined that the rate equation for bacterial kill in batch chlorine contact chambers is: rxn rate = dC/dt=-kCt where C is the concentration of bacteria, k is the rate constant, and t is time.

  Determine suitable footing dimensions to suit the bearing

Determine suitable footing dimensions to suit the bearing capacity of 100kPa with a factor of safety 2.4

  Determine the distance d between a and b at the instant

At a given instant, the position of a plane at A and a train at B are measured relative to a radar antenna at O. Determine the distance d between A and B at this instant.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd