Estimate the power cost per 8000 operating hours

Assignment Help Chemical Engineering
Reference no: EM131061339

A blower is being used to force 200 lb of air per hour through a 12-in. inside-diameter tower countercurrent to water flowing at a rate of 6000 lb/h. The tower is packed to a height of 10 ft with 1-in. Berl saddles. The average pressure in the tower is 1 atm, and the temperature is 75°F. The blower-motor combination used at the gas inlet has an overall efficiency of 50 percent. Estimate the power cost per 8000 operating hours for forcing the air through the packing if the cost of power is $0.08 per kilowatt hour.

Reference no: EM131061339

Questions Cloud

Construct the circuit in multisim using the resistor values : Construct the circuit in Multisim using the resistor values you chose and tolerances. Do a screenshot showing how you have set up the tolerances for the resistors.
What were major causes of the decline of the roman emperors : The Five Good Emperors are considered the model of Roman government during the Pax Romana. What are the reasons for this approval? What makes these rulers different from other emperors? Hint: how did they come to power?
Activity increases with water temperature : Joey read in his biology book that fish activity increases with water temperature, rest is attached because. It includes a picture
Computer game that required her : Ms. Amber Dextrous played a computer game that required her. The rest is attached because it has a picture
Estimate the power cost per 8000 operating hours : The blower-motor combination used at the gas inlet has an overall efficiency of 50 percent. Estimate the power cost per 8000 operating hours for forcing the air through the packing if the cost of power is $0.08 per kilowatt hour.
Write a formal proposal fulfilling the plcpas rfp : Write a formal proposal fulfilling the PLCPA's RFP. You will be assigned to a group, and you and your team must all collaborate with one another on all ideas and writing for the assignment.
Determine the installed cost tube length and number of tube : All other conditions are the same as those specified in Example 5 of this chapter, except that Bi is not given. 8. Present a detailed derivation of Eq. (481 in this chapter, using, as a starting point, any of the other equations that are given.
What is your opinion of the quiescent operating point : What is your opinion of the Quiescent Operating Point (Q-Point)? Do you feel this is the mandatory level that is used to optimize a transistor biasing design in a circuit?
What are the pros and cons of a drg payor system : Discuss your viewpoints on the question of whether patients can adequately understand and judge the quality of the health care services they receive

Reviews

Write a Review

Chemical Engineering Questions & Answers

  Determine the limiting reactant

Calculate the mass feed rate of hydrogen (kg/s) required to produce 4 x 106 metric tons of ethane per year, assuming the reaction goes to completion and that the process operates for 24 hours a day and 300 days a year. (20.6 kg H2/s)

  Development of microstructure

In terms of heat treatment and the development of microstructure, what are two major limitations of the iron-iron carbide phase diagram?

  How the pressure in the tank varies with time

Develop a mathematical model that describes how the pressure in the tank varies with time.

  Calculate the line voltage at the secondary terminals

Calculate the line voltage at the secondary terminals of the transformer if the load is disconnected from the transformer. Assume that the input voltage to the transformer remains unchanged. Neglect core loss and magnetizing current

  Evaluation of ideal gas volumes-steady state mass balance

Here you compare the value of H when you use actual data (steam tables) and when you assume ideal gas. Reference means H = 0. State all reasonable assumptions. Vapor-liquid phase partitioning is involved.

  Heated from a pipeline temperature

Water (1.25 kg/s) is to be heated from a pipeline temperature of 15°C to 85°C using superheated steam (13.75 kg/s) at 550°C and 3 MPa in a steady-state process to produce 15 kg/s of heated water. The heating is to be done in a mixing tank by directly..

  What is the total solar power received by the box

Kyoto box is a simple solar oven used extensively in Africa. Assuming a square box with four reflectors of L = 75 cm, on a sunny day with direct sunlight from the zenith, what is the optimum angle ?? What is the total solar power received by the b..

  100 psia as the steam is admitted to the cylinder

(1) Determine the mass and the temperature of the steam in an insulated piston-cylinder arrangement if sufficient steam is admitted to displace the piston by one cubic foot. The cylinder originally is empty, and the piston main- tains a constant pres..

  What is the settling velocity in still air of a particle

What is the settling velocity in still air of a particle that is 40 µm in diameter and spherical? The particle has a density of 1400 Kg/m3. Use a density of 1.2 Kg/m3 and a viscosity

  The combustion of hydrogen and in the moisture

When burnt , the flue gas issuing out of the furnace at 545 oc analyses on dry basis as CO2 =14.5 % , O2 = 4.7%, N2 = 80.8 % , Other relevant data are- Gross C.V. of coal =28000 kj /kg , ambient temperature = 15oc

  Independent of concentration

QUESTION  -  1 . The rate  of a liquid phase  reaction  of the type ,A+B --àproducts  is  found to be  independent  of concentration of A and B  and  equal  to 1 KMOL/m3  ( min)   at 300  ok

  Why a substance is being heated at a fast rate the

why a substance is being heated at a fast rate the temperature of decomposition will be the higher than the obtain at a

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd