Estimate the moisture picked up by 1 kg of dry air and the

Assignment Help Mechanical Engineering
Reference no: EM13643447

A grain dryer consists of a vertical cylindrical hopper through which hot air is blown. The air enters the base at 1.38 bar, 65 degree C, 50% RH. At the top, saturated air is discharged into the atmosphere at 1.035 bar, 60 degree C. Estimate the moisture picked up by 1 kg of dry air, and the total enthalpy change between the entering and leaving streams expressed per unit mass of dry air.

Reference no: EM13643447

Questions Cloud

Find the temperature to which the air is cooled and the : an air-conditioned room requires 30 m3 min of air at 1.013 bar 20 degree c 52.5 rh. the steady flow conditioner takes
Suppose the clay ball is dropped from the ceiling onto an : a massless pan hangs from a spring that is suspended from the ceiling. when empty the pan is 52 cm below the ceiling.
Determine the mass flow rate of spray water and the power : an industrial process requires an atmosphere having a rh of 88.4 at 22 degree c and involves a flow rate of 2000 m3h.
Cooling water enters a cooling tower at a rate of 1000 kgh : cooling water enters a cooling tower at a rate of 1000 kgh and 70 degree c. water is pumped from the base of the lower
Estimate the moisture picked up by 1 kg of dry air and the : a grain dryer consists of a vertical cylindrical hopper through which hot air is blown. the air enters the base at 1.38
The radius of the earth is 6380 km and turns once on its : the radius of the earth is 6380 km and turns once on its axis in 24 hours. what is the radial acceleration if the
A 20 microf capacitor and a 40 microf capacitor are : a 2.0 microf capacitor and a 4.0 microf capacitor are connected in series across 1000v. the charged capacitor are then
What percentage of the water flow rate must be supplied as : air enters a counterflow cooling tower at a rate of 100 m3s at 30 degree c dbt and 40 relative humidity. air leaves at
An astronaut on the planet zircon tosses a rock : an astronaut on the planet zircon tosses a rock horizontally with a speed of 6.95 ms. the rock falls through a vertical

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Steam flows through an expansion valve conditions at the

steam flows through an expansion valve. conditions at the inlet are p1700 kpa and x10.96. the exit pressure p2 is 350

  How does data screening differ from data cleaning

.How does data screening differ from data cleaning?

  T vertical motion of mass a is defined by the relation

the vertical motion of mass a is defined by the relation x10sin2t15cos2t100. determine a the position velocity and

  The main shaft of a particular machine is to continuously

the main shaft of a particular machine is to continuously transmit 25.0 ft-lbs of torque say along the z-axis. it is

  The uniform disk of mass pivots freely on the cart of mass

the uniform disk of mass pivots freely on the cart of mass. determine the acceleration of the assembly and the angular

  The load is supported by the four 304 stainless steel wires

the load is supported by the four 304 stainless steel wires that are connected to the rigid members ab and dc.

  Using the general form of the reynolds transport theorem

using the general form of the reynolds transport theorem derive the equation of conservation of linear momentum for a

  If the average germans mouth is located 140 cm above the

in order to improve business the wiessherr biergarten in augsburg germany began a new gimmick promotion the bier

  What is the initial temperature of the water

A piston-cylinder device contains 0.005 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 600 kPa. Heat is transferred at constant pressure until the temperature reaches 200°C.

  A vehicle is powered by motors that have a maximum speed of

a vehicle is powered by motors that have a maximum speed of 5000 rpm. each motor is coupled to the wheel using a gear

  How far below the liquid level in the tank must the pump be

a feed rate of 200gpm of a hydrocarbon mixture at 70c is being pumped from tank at 1 atm abs pressure to a distillation

  The pressure of the gas varies linearly with volume during

air in a piston-cylinder assembly expands slowly from an initial state where the pressure is 250 kpa and the volume is

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd