Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
An x-ray "monochrometer" is a mirror that reflects only a single wavelength from a broadband beam of x-rays. Over 99% of the beam's energy arrives on other wavelengths and is absorbed creating a high heat flux on part of the surface of the monochrometer. Consider a monochrometer made from a silicon block 10 mm long and 3 mm by 3 mm in cross-section which absorbs a flux of 12.5 W/mm2 over an area of 6 mm2 on one face (a heat load of 75 W). To control the temperature, it is proposed to pump liquid nitrogen through a circular channel bored down the center of the silicon block. The channel is 10 mm long and 1 mm in diameter. LN2 enters the channel at 80 K and a pressure of 1.6 MPa (Tsat = 111.5 K). The entry to this channel is a long, straight, unheated passage of the same diameter.
a. For what range of mass flow rates will the LN2 have a bulk temperature rise of less than 1.5 K over the length of the channel?
b. At your minimum flow rate, estimate the maximum wall temperature in the channel.
As a first approximation, assume that the silicon conducts heat well enough to distribute the 75 W heat load uniformly over the channel surface. Could boiling occur in the channel?
Discuss the influence of entry length and variable property effects.
A cylinder-piston assembly contains saturated liquid (H20) at 500F. The piston is 1 inch from the bottom of the cylinder. The system undergoes a constant temperature in which the fluid expands and the piston is raised to 86.45 inches above the bottom..
a well-insulated rigid tank of volume 10 m3 is connected by a valve to a supply line carrying air at 227oc and 10 bar.
a small sphere is at rest at the top of a frictionless semicylindrical surface. the sphere is released at the top of
Calculate the force constant for the bond.
an iron ball is thrown into the atlantic ocean. density of iron is 7856 kgm3. density of salt water is 1020 kgm3.
---a heat engine operates between two heat reservoirs with temperature of 560 and 280 k. the thermal efficiency of the
a power plant is analyzed as a simple ideal rankine cycle with a boiler operating at 300 oc. steam leaves the boiler
each of the two slender rods is .75m long and has a mass of 6 kg. each rod has a moment of inertia of iml212 about the
While the outer surface exposed to the ambient air at 30oC with heat transfer co-efficient of 17 W/m2K. Calculate heat loss for 3 m length of the tube.
If the efficiency of the turbine in converting the mechanical energy given up by the fluid to the turbine shaft is 89% (nt = 0.89), calculate the friction loss in the turbine in J/kg.
Refrigerant 134a at 30 lbf/in.2, 408F enters a compressor operating at steady state with a mass flow rate of 150 lb/h and exits as saturated vapor at 160 lbf/in.2 Heat transfer occurs from the compressor to its surroundings, which are at 408F. Cha..
Water is heated in a closed pot on top of a stove while being stirred by a paddle wheel. During the process, 30 kJ of heat is transferred to the water, and 5 kJ of heat is lost to the surrounding air. The work done amounts to 500 J. determine the fin..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd