Estimate the interior convective heat transfer coefficient

Assignment Help Mechanical Engineering

Reference no: EM13714116

Hot water at 90 degrees C flows through a carbon-steel tube whose ID is 2 cm and OD is 3 cm, at a bulk velocity of 30 m/s. The length of the tube is 10 m. The exterior natural convection coefficient is 8 W/m²*K and the ambient temperature is 25 degrees C.

a) Estimate the interior convective heat transfer coefficient.

b) Calculate the rate of heat loss through the wall of the tube.

c) Find the interior surface temperature.

Reference no: EM13714116

Questions Cloud

Roll three 6-sided dice and flip a coin : 1) Experiment: Roll three 6-sided dice and flip a coin then record the results a) Describe a suitable sample space for the experiment that contains equally likely outcomes. b) Find the probability that the total sum of the three dice is 6 and the coi..

The fluid density-viscosity and revolutions per unit time : The thrust, T, of a marine propeller is assumed to depend only on its diameter, D, the fluid density, the viscosity, the revolutions per unit time, and its forward velocity, V. Express this dependence in non-dimensional terms. Is one of the ?–product..

Determine factor of saftey of gears in bending : A 17-tooth 20 normal pressure-angle helical pinion with a right-hand helix angle of 30 rotates at 1800 rev/min when transmitting 4 hp to a 52-tooth helical gear. The normal diametrical pitch is 10 teeth/in, the face width is 1.5 in, and the set has a..

Emperor penguin in antarctica may be modeled as cylinder : An Emperor penguin in Antarctica may be modeled as a cylinder 1m high with a diameter of 0.2m. The male Emperor penguin warms his egg for sixty-four days during the Antarctic winter (no solar input), in deep sub-zero temperatures. During this time th..

Estimate the interior convective heat transfer coefficient : Hot water at 90 degrees C flows through a carbon-steel tube whose ID is 2 cm and OD is 3 cm, at a bulk velocity of 30 m/s. The length of the tube is 10 m. The exterior natural convection coefficient is 8 W/m2*K and the ambient temperature is 25 degre..

Magnitude plot-make sure to calculate zeta for complex peaks : Sketch Bode plots for the following systems. Use asymptotes, but locate at least one point in the Magnitude plot and make sure to calculate zeta for complex peaks.

The thermal efficiency of a general heat engine : The thermal efficiency of a general heat engine is 40 percent, and it produces a net work of 30hp. At what rate is heat transferred to this engine in kj/s?

Determine the power required to run the heat pump : A heat pump operating at steady state provides 36,000 kJ/hr to maintain the temperature in a building at 22C. The heat pump operates with a coefficient of performance 75% that of a reversible cycle operating between the same thermal reservoirs.

Determine the size of the rivets to be used for the joint : The bracket plate is 25 mm thick. All rivets are to be of the same size. Load on the bracket, P = 50 kN ; rivet spacing, C = 100 mm; load arm, e = 400 mm. Permissible shear stress is 65 MPa and crushing stress is 120 MPa. Determine the size of the ri..

User Account

All Pages