Estimate the flow rate of water required to make the outflow

Assignment Help Civil Engineering
Reference no: EM13564907

A mixing chamber has two steady streams and one steady stream. The properties of the first stream is superheated steam at T1 = 400oF, h1 = 1,239 Btu/lbm and flow rate m1 = 20 lbm/h. The second stream is compressed liquid at T2 = 70oF, h2 = 38 Btu/lbm. If the rate of heat removal from the chamber is 15,000 Btu/h; i. Sketch and label the mixing chamber. ii. Estimate the flow rate of water required to make the outflow stream be a saturated liquid water at 212oF. Inflow. Specify the necessary assumptions.

Reference no: EM13564907

Questions Cloud

How long the contractor will have to wait before he can : A contractor brought 10,000 cubic yard of soil to site to create a ramp. The water content of the soil is 30%. According to the engineer, the soil is too wet, and should be dried to 20% water content before it can be placed and compacted. The contrac..
Find the total magnetic flux through the cylinder : A long, straight wire carrying a current of 2.00 A is placedalong the axis of a cylinder or radius 0.500 m and a length of 3.00m. Determine the total magnetic flux through the cylinder
Determine the posted speed limit to the nearest 5 mph : A building is located 19 ft from the centerline of the inside lane of a curved section of highway whose radius is 400 ft. The road is level and e = 10. Determine the posted speed limit (to the nearest 5 mph) considering the following conditions:
Determine the improvement in efficiency and circulation rate : Now you want to improve the efficiency and circulation rate. You suggest operaing the cycle utilizing two reversible tubines with saturated vapor exit streams. All conditions remain the same except that the feed to the first turbine is steam at 450 C..
Estimate the flow rate of water required to make the outflow : A mixing chamber has two steady streams and one steady stream. The properties of the first stream is superheated steam at T1 = 400oF, h1 = 1,239 Btu/lbm and flow rate m1 = 20 lbm/h. The second stream is compressed liquid at T2 = 70oF, h2 = 38 Btu/lbm..
Determine the volume flow rate of the steam at the nozzle : A steady-state, well-insulated turbine operates in two stages in series using steam. the first stage has an efficiency of 85% and the second stage 90%. Steam enters the first stage at 400 C and 4 MPa and exits at 1.5 MPa.
Determine the volume flow rate for this particular water : Everyone has experienced using a water fountain that produces a bit too much water pressure. In fact, the drinking fountain on the 3rd floor of Dana Hall at the south end of the hallway shoots a pretty good jet of water
Show this operation on a linear schedule : A project consists of replacing the track on an existing railroad line, involving 3000 feet of track. The old track can be removed at a rate of 70 feet per hour. The old railroad ties can be removed at a rate of 200 feet (measured along the track) pe..
What is the project duration if no activities are to be : A 1500-foot subdivision street is to be constructed. The layout will be completed in three days; the fill will be brought in over the course of eight days; the compaction/grading will be completed in five days

Reviews

Write a Review

Civil Engineering Questions & Answers

  Provide a reasonable design for a efficient esp treating

The particles have an effective drift velocity of 10.0 cm/s. Specify the total plate area, channel width, number and size of plates, number of electrical sections (total and in direction of flow), and total corona power to be supplied, and estimat..

  How to compute the normal depth of a trapezoidal channel

A trapezoidal channel with a bottom width of 4 feet and side slopes 2:1 (H:V) and a bed slope of 1 percent conveys a discharge of 50,000 gpm. Assume n = 0.025. Compute the normal depth.

  What is loss in truck operating cost for the logging company

The performance functions of these three routes are: t1=50+0.2v1, t2=80+0.1v2, t3=120 + 0.05v3 t1, t2, t3 and are travel times in minutes; v1, v2, v3 are flows in number of trucks per day.

  Find size of tank that has to be designed for water supply

(i) volume to supply the peak demand of 1.8 times the average demand. (ii) volume to supply fire flow for at least 9 hours, and (iii) volume to supply emergency storage 600 L/day/capita. (1 L = 0.001m^3)

  Determine factored uniform load per foot which beam supports

Structural steel beams are to be placed at 7ft 6in on center under a reinforced concrete floor slab. If they are to support a service dead load D=64 psf of floor area and a service live load L=100 psf of floor area

  Find an equation of a plane containing the three points

Find an equation of a plane containing the three points (-2, 5, -3), (-7, 3, 1), (-7, 4, 3) in which the coefficient of x is -8.

  Revolve the pavement about its inside edge

Calculate the super-elevation required for a horizontal curve on a two-lane, two- way highway with 60 mph design speed, and a 1200 ft. radius curve. What is the required length of the spiral curve?

  Determine the height and the velocity of the water

The centres of the piers in a bridge are 8.0m apart. The piers are each 0.8m wide. Water flow under the bridge with an upstream depth and velocity of 4.0m and 4.0m/s respectively. The pier has a drag coefficient Cd = 1.5.

  Calculating the relative compaction of a dam project

A dam project specifies 97% compaction. Lab tests on the soil being used indicate that it has a maximum dry density of 1900 kg/m 3 at an optimum water content of 13.2%.

  How many plates are needed to collect with regulations

In order to comply with regulations, an iron/steel sinter plant installs an electrostatic precipitator (ESP) to collect 98% of the 10 ?m particles from an air stream flowing at 2 m3/s

  What is the equivalent height of a water column

Tall buildings can develop a significant difference in pressure between the inside and the outside of the building. Air lock entrances are used at the ground level so the pressure at the ground floor is not the same as atmospheric pressure. Assume th..

  What is theta when the string reaches the length r2

A marble on the end of a massless string is rotating about a hole at O on a flat(horizontal) frictionless table. The mass originally rotates with an angular velocity theta'=w0 and r is constant at r1.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd