Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A confined aquifer is 50 m thick. The potentiometric surface elevations at two observation wells 1,250 m apart are 26.35 m and 27.90 meters. If the aquifer consists of 50% medium-grained sandstone and 50% medium sand: A) Estimate the aquifer porosity and hydraulic conductivity, B) determine the flow rate per unit width of the aquifer, C) determine the specific discharge, D) determine average linear velocity of the flow assuming steady unidirectional flow, and E) calculate how long would it take for a tracer to travel the distance between the observation wells.
Determine the operating speeds of the machine at which the machine's steady-state amplitude is less than 0.2 mm. Take keq = 3 EI/L3.
A MH at an intersection has an inflow from three 8-inch PVC (n = 0.01) sanitary sewer pipes laid at minimum slope converging at an intersection and one pipe taking the flow from those three further downstream.
How many moles of aluminum do 5.2×1024 aluminum atoms represent?
A lagoon with a volume of 1200 m^3 has been receiving a steady flow of a conservative waste at a rate of 100m^3/day for a long enough time to assume that steady-state conditions apply. The waste entering the lagoon has a concentration of 10mg/L.
A 10-mm diameter bar of 1040 carbon steel is subjected to a tensile load of 50,000 N, taking it beyond its yield point. Calculate the elastic recovery (or strain) that would occur upon removal of the tensile load.
An equal-tangent crest vertical curve is designed with a PVI at station 110+00 and a PVC at station 107+43.3. if the high point is station 110+75.5 what is the design speed of he curve?
Compute the maximum acceptable tensile load Pu, on an angle L6x4x3/4 when connected to both legs. The 4 in. leg contains a single gage line of 7/8in. diameter bolts, and the 6in.
What is the risk of constructing a harbor which will be unprotected from wave attack during its construction.
The horizontal motion of plunger and shaft is arrested by resistance of the attached disk which moves through the oil bath. If the velocity of plunger is v.
The point of intersection of the tangents is located at station (948+67.32). If the design speed of the highway is 60mi/h, determine both the point of tangent and the deflection angles to whole stations for laying out the curve. Select appropriate..
Briefly explain how each of the following influences the tensile or yield strength of a semicrystalline polymer and why: (a) Molecular weight (b) Degree of crystallinity (c) Deformation by drawing (d) Annealing of an undeformed material
If a car engine is turning at 4000 rpm, the transmission gear ratio is 3:1 and the final drive ratio is 4:1. (a) what is the speed in rpm of the car wheels and (b) the vehicle speed if the tire radius is 8 inches
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd