Estimate its fatigue life using the palmgren-miner linear

Assignment Help Civil Engineering
Reference no: EM131069856

The S-N curve for an elastic material is characterized by the Basquin relationship σa= C . Nbf where C is a material constant σa, a is the stress amplitude, Nf is the number of fully reversed stress cycles to failure and b is the Basquin exponent approximately equal to -0.09. When the stress amplitude is equal to the ultimate tensile strength of the material in this alloy, the fatigue life is 1/4 cycle. If a specimen spends 70% of its life subject to alternating stress levels equal to its fatigue endurance limit σe, 20% at l.lσe estimate its fatigue life using the Palmgren-Miner linear damage rule.

Reference no: EM131069856

Questions Cloud

What conditions would you expect the principal stresses : Under what conditions would you expect the principal stresses to be nearly aligned with the axial and hoop directions?
Make a contribution to the job and the entire company : Does GE use our definition of leadership ("the influencing process of leaders and followers to achieve organizational objectives through change")?
Analysis of experimentation and observation : Compile a PowerPoint with your analysis of experimentation and observation as they apply to your company and/ordiscipline. In your PowerPoint, be sure to address the following questions/topics:
Design an employee program or incentive : For example, analyze an employee program or incentive using one of these theories and evaluate its effectiveness in terms of motivating employees and achieving desired results. Or select one theory and design an employee program or incentive that ..
Estimate its fatigue life using the palmgren-miner linear : If a specimen spends 70% of its life subject to alternating stress levels equal to its fatigue endurance limit σe, 20% at l.lσe estimate its fatigue life using the Palmgren-Miner linear damage rule.
Why is ge so successful : CEO Jeff Immelt says that you either get out ahead of new trends or you get stomped by them. GE is so successful because for more than 100 years it has been a world leader in getting ahead of trends.
Ge use our definition of leadership : We begin each chapter by introducing an exceptional leader and company, followed by some questions for you to answer, and we answer the questions throughout the chapter.
Foundations and corporate giving programs : Prompt: Most grants awarded by foundations and corporate giving programs can be categorized as one of two types:
Construct the circuit on your breadboard : using complete sentences, describe the objectives of the exercise.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the aeration period and f by m ratio

Two activated sludge aeration tanks in Podunk, MO are operated in series. Each tank has the follwing dimensions: 7.0 m wide x 28.0 m long x 3.5 m effective liquid depth.

  What is the mass flow rate of the refrigerant

A refrigerator operates on the ideal vapor compression refrigeration cycle with R-134a as the working fluid between the pressure limits of 120 and 800 kPa

  What is the rolling resistance

He is concerned about the high rolling resistance of the units in the sand (RR factor 250lb/ton).  What is the rolling resistance?

  Calculate the absolute viscosity of the oil in a large tank

A 6-inch diameter steel sphere (sg = 8.0) is released in a large tank of oil (sg = 0.86). The terminal velocity of the sphere is measured at 13.5 ft/s. Calculate the absolute viscosity of the oil.

  Draw streakline-pathline of the particle and streamline at t

A dye streak was started at a point in the flow field at time t=0, and the path of a particle in the fluid was also traced from that same point starting at the same time. Draw the streakline, pathline of the particle, and streamlines at time t=10s..

  Determine what is the probability that all eight bits are 1

In a random pattern of eight bits used to test a micro-circuit, each bit is equally likely to be 0 or 1. Assume the values of the bits are independent. a. What is the probability that all eight bits are 1

  Calculate how many chlorine atoms will be in an average

Calculate how many chlorine atoms will be in an average neoprene chain? b) Sketch the bonding between polychloroprene chains due to sulfur linkages as neoprene is vulcanized into an elastomer. c) You decide to go swimming in Bear Lake in late Novembe..

  Find the downstream depth and the head loss in the jump

a hydraulic jump is to be formed in a trapezoidal channel with a base width of 20ft and a side slope of 2:1. The upstream depth is 1.25ft and Q=1000 cfs. Find the downstream depth and the head loss in the jump.

  The mass center of the unbalanced disk of weight w is locate

The mass center of the unbalanced disk of weight W is located at G, which is a distance of R/2 from the center for the disk. In the equilibrium postition

  Determine immediately after release angular acceleration

Assuming that the friction force between end A and the surface is large enough to prevent sliding, determine immediately after release (a) the angular acceleration of the rod, (b) the normal reaction at A, (c) the friction force at A

  What would the spindle diameter need to be in order to move

The crane hoists a uniformly distributed load C. the two identical motors at A an power through gearboxes operating at maximum output speed of 100 rpm.the load is lifted by winding cable onto spindles attached to the output shaft of each gear box.

  Determine what is the composition and microstructure

It is desired to produce an iron-carbon allow that has a minimum hardness of 200 HB and a minimum ductility of 35% RA. Is such an ally possible. If so what its composition and microstructure

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd