Equivalent resistance of all five resistors

Assignment Help Chemical Engineering
Reference no: EM131877948

Five resistors are connected purely in series to a battery of 38 volts. Three of these resistors are equal (equal to R) and the voltage across each is 3.1 volts. The resistance of the fourth resistor is a factor 3.3 times smaller than R. If the equivalent resistance of all five resistors is 21 Ohms, what is the power, in Watts, dissipated by the fifth resistor?

Reference no: EM131877948

Questions Cloud

Peak corresponding to a pothole : If the potholes are spaced a distance 1.2 m apart what speed must the driver avoid driving at to prevent damaging the car?
Find the magnitude of the acceleration of the flea : Find the magnitude of the acceleration of the flea if its mass is 6.3 x 10-7 kg. Do not neglect the force of gravity and give your answer in microns per square
Establish a competitively powerful value chain : Build competitive advantage in the marketplace by giving buyers superior value relative to the offerings of rival sellers.
Read the article on density altitude : Read the article on density altitude. Is it more important for pilots to be aware of density altitude during hot weather compared to colder weather? Why
Equivalent resistance of all five resistors : If the equivalent resistance of all five resistors is 21 Ohms, what is the power, in Watts, dissipated by the fifth resistor?
Is it okay to have the patient execute a hcp : You are the nurse manager of a medical surgical floor. An intellectually disabled patient is admitted accompanied by her sister.
Determine the post collision speed of the cue ball : The 5 ball immediately speeds up to .52m/s. Determine the post collision speed of the cue ball.
What is the magnitude and direction of the net : What is the magnitude and direction of the net acceleration on the ball.
Discuss human resource information systems : Human Resources (HR) is a field that deals with policies, procedures, compliance requirements, and best practices. Developments in online systems increased.

Reviews

Write a Review

Chemical Engineering Questions & Answers

  How much heat is transferred in the process

Which phase (liquid or vapor) remains, and what are its temperature and pressure? How much heat is transferred in the process?

  Design a hydro cyclone system to handle

A recovery of 95% of particles greater than 100 μm is required. The minimum operating temperature will be 10 °C and the maximum 30 °C. Design a hydro cyclone system to handle 1200 liters/min of this slurry.

  Calculate the density of atoms along

Calculate the density of atoms along [011] in molybdenum (Mo). Express your answer in units of atoms/cm.

  Find the voltage across the 50-? resistor

Then find the voltage across the 50-Ω resistor and the total power supplied by the source

  Find the air fuel ratio for stoichiometric combustion

Find the air fuel ratio for stoichiometric combustion of Butane by volume. Calculate the percentage of carbon dioxide present in the DRY flue gas if 30% excess air is used

  What is the composition of the product gas on a water-free

Ethylene is produced by the dehydrogenation of ethane. If the feed includes 0.5 mol of steam (an inert diluent) per mole of ethane and if the reaction reaches equilibrium at 1100 K and 1 bar, what is the composition of the product gas on a water-f..

  Developing new lithographic techniques

What is the wavelength regime of each of the lithographic techniques listed in Problem 9? (red-visible light, green-visible light, blue light, UV (E=SeV), e-beam (acceleration voltage of 10 keV), and x-ray).

  Determine the required value of the flux density

Determine the required value of the flux density.

  Estimate the power cost per 8000 operating hours

The blower-motor combination used at the gas inlet has an overall efficiency of 50 percent. Estimate the power cost per 8000 operating hours for forcing the air through the packing if the cost of power is $0.08 per kilowatt hour.

  Determine the required value of the flux density

A 100-turn coil in the configuration of Figure P12.1.3 is rotated at a constant speed of 1200 r/min in a magnetic field. The rms induced voltage across the coil is 1 kV, and each turn has a length l = 112.5 cm and a width w = 10 cm. Determine the ..

  Determination of the discharge coefficient of the orifice

This is a fluid dynamics experiment involving the filling and emptying of tanks. The objectives of the experiment include: Determination of the discharge coefficient of the orifice and the equivalent length of a pipe mounted at the outlet of the two..

  What mass of na2 38so4 has an activity of 10.0 mci

The curie (Ci) is a commonly used unit for measuring nuclear radioactivity: 1 curie of radiation is equal to decay events per second (the number of decay events from 1 g of radium in 1 s).

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd