Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Enlist the engineering benefits of using concrete for structures.
The siphon crown is 1.2m above the water surface elevation of the reservoir and a length 10m away from the siphon entrance. If the siphon diameter is 30 cm, if the friction factor is .02, and the headless coefficient are .2 (inlet) and 1 (exit),
Traction and Total Resistance, Would you please help me with the following question: A 90 tonne rear dump truck travels on an 8% grade loose gravel road.
A short concrete column is being used to support the roof over a pedestrian walkway. The unbraced column length is 9 feet and supports a dead load of 12 kips and a live load of 20kips.
A supervisor is sitting at her desk illuminated by a 180 candela source 3 feet above it. She is writing with green ink (reflectance=30%) on a yellow note pad (reflectance=60%). What is the illumination on the note pad?
A motorcycle starts from rest at time t=0. The force on it from t=0to 30 seconds is F=300-9t. The combined mass of the motorcycle andthe rider is 225 kg. Use the Impulse and Momentum method to find the magnitude of the velocity at t=30 seconds.
A turbine expands to a pressure of 10 kPa and a quality of 0.94. Determine the temperature T and the specific volume at this state.
Assume the capacity of a pile supporting a transmission tower is modeled with a log-normal random distribution with a mean of 250 tons and a c.o.v. of 20%. a) What is the probability that the pile will survive a load of 275 tons
A car is traveling on a paved road with CD = 0.35, Af = 21 ft2, W = 3000 lb, ? = 0.002378 slugs/ft3. Its engine is running at 3000 rpm and is producing 250 ft-lb of torque. The car’s gear reduction ratio is 3.5 to 1
Determine the discharge of a trapezoidal concrete channel section with a bottom width of 4 ft and side slopes of 2:1. The depth of flow is 5 ft and the channel slope is 0.5%
A 900-mm strip of steel is bent into a full circle by two couples applied. Determine (a) the maximum thickness t of the strip if the allowable stress of the steel is 420 MPa, (b) the corresponding moment M of the couples.
If a manometer was used to measure the pressure drop and the fluid in the manometer was an oil with a specific gravity of 0.84, what would the vertical displacement of the oil menisci be for 1 inch of water pressure difference?
The question asks for the magnitude and direction at the pin Aand int the cable BC needed to support a 500-lb ball load. The boomweight AB is neglected. AB is 8ft long and angled at 35degrees. The cable BC has an angle of 22 degrees and the500-lb bal..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd