Engine operated between two heat reservoirs at temperatures

Assignment Help Physics
Reference no: EM13536862

A Carnot engine is operated between two heat reservoirs at temperatures of 300K and 400K.

a. If the engine recieves 1200kJ from the reservoir at 400K in each cycle, how much heat is transferred to the reservoir at 300K?

b. If the engine is operated as a refrigerator and recieves 1200kJ from the reservoir at 300K, how much heat does it deliver to the reservoir at 400K?

c. How much work is done by the engine in each case?

d. What is the efficiency of the engine and the coefficient of performance of the refrigerator?

e. Sketch a T-S graph for the heat engine.

Reference no: EM13536862

Questions Cloud

A projectile is fired from the origin : A projectile is fired from the origin (at y = 0 m) as shown in the figure. The initial velocity components are = 920 and = 79 . The projectile reaches maximum height at point P, then it falls and strikes the ground at point Q. In the figure, the y-co..
Temperature-relative humidity on leeward side of mountains : Westerly winds coming off the Pacific Ocean rise over the Rocky Mountain, which rise to a height of approximately 15,000 ft (580 hPa). The air on the western side of the mountain range is at 800 hPa (T = 70F, r = 0.75), and will subside on the easter..
Heat absorbed and the change in internal energy during : Calculate the work done, the amount of heat absorbed, and the change in internal energy during: melting of 1 gram of ice to water at a temperature of O degrees Celsius under a constant pressure of 1 atmosphere
What is the kinetic energy of proton-oscillator frequency : In a certain cyclotron a proton moves in a circle of radius 0.750 m. The magnitude of the magnetic field is 1.60 T. (a) What is the oscillator frequency (in Hz)? (b) What is the kinetic energy (in eV) of the proton?
Engine operated between two heat reservoirs at temperatures : A Carnot engine is operated between two heat reservoirs at temperatures of 300K and 400K.
Use the ground-state wave function : Use the ground-state wave function of the simple harmonic oscillator to find Δx. Assume that α=mω/h_ E=(1/2)h_*ω
Find the inertia tensor for a uniform : Find the inertia tensor for a uniform, thin hollow cone, such as an ice-cream cone, of mass M, height h, and base radius R, spinning about its pointed end.
Is the voltage at the hot wire positive or negative-explain : Electrons can be “boiled off” of a wire by heating the wire to sufficiently high temperature (typically well over 1000? C). Typically the electrons leave the wire with a fairly low speed which can be approximated as zero
The gold electrode the reaction : Let’s do some electrochemistry. A process for electroplating an object with gold is as follows. The object to be electroplated is immersed in a bath of gold chloride (AuCl4-) and connected to the negative terminal of a battery.

Reviews

Write a Review

Physics Questions & Answers

  What is the mass of the car in kilograms

In a college homecoming competition, eighteen students lift a sports car. Though holding the car off the ground, each student exerts an upward force of 390 N. What is the mass of the car in kilograms? What is its weight in pounds.

  Calculate the required peak voltage

An inductor (L = 400 mH), a capacitor (C = 4.43 ?F), and a resistor (R = 500 ?) are connected in series. Calculate the required peak voltage

  Determine what is the magnitude of the resultant vector

Two vectors of magnitude 22.6 N and 24.5 N act at right angles to each other. What is the magnitude of their resultant vector

  At what wavelength is the intensity of emitted light highest

A typical incandescent lightbulb has a filament temperature of approximately 3191 K. At what wavelength is the intensity of the emitted light highest

  What should be the focal length of the second lens

You have a converging lens with a focal length of 0.85 m, and wish to construct a refracting telescope with an angular magnification of âˆ'45. what should be the focal length of the second lens

  What volume would this air occupy at stp

A 16 cm-diameter compressed-air tank is 30 cm tall. The pressure at 20 degrees C is 140 atm. What volume would this air occupy at STP

  Compute the total mechanical energy

An aluminium block of mass m1 = 3.45 kg and a copper block of mass m2 = 6.30 kg are connected by a light string over a frictionless pulley. They sit on a steel surface, where θ = 40.0°

  How long does it take the boat to reach the buoy

A speedboat moving at 33.0 m/s approaches a no-wake buoy marker 100 m ahead. The pilot slows the boat with a constant acceleration of ?3.20 m/s2 by reducing the throttle. (a) How long does it take the boat to reach the buoy? (b)What is the velocit..

  Find the period of rotation after collapse

A star with an initial radius of 1.00 108 m and period of 30.0 days collapses suddenly to a radius of1.00 104 m. Find the period of rotation after collapse

  What is their distance of closest approach

A proton and an alpha particle (q = +2e, m = 4 u) are fired directly toward each other from far away, each with an initial speed of 0.012c. What is their distance of closest approach

  How much time the rocket clear the top of the wall

A rocket is fired at a speed of 82.0 m/s from ground level, at an angle of 38.0 ° above the horizontal, By how much does the rocket clear the top of the wall

  Find the elecric field intensity vector at the origin

A +10 nC charge is placed on the x-axis at x= -6cm. A +8 nC charge is placed 14cm away on the x-axis at x= +8 cm. A) find the potential at the origin

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd