Electricity supplied to the water heater

Assignment Help Mechanical Engineering
Reference no: EM13950393

An electric water heater having a 200-L capacity heats water from 23 to 55°C. Heat transfer from the outside of the water heater is negligible, and the states of the electrical heating element and the tank holding the water do not change significantly. Perform a full exergy accounting, in kJ, of the electricity supplied to the water heater. Model the water as incompressible with a specific heat 5 4.18 kJ/kg ? K. Let T0 5 23°C.

1378_electricity supplied to the water heater.png

Reference no: EM13950393

Questions Cloud

Complete a consolidated worksheet for untraded company : Complete a consolidated worksheet for Untraded Company and its subsidiary, Traded Company, as of January 1, 20X2.
Create all necessary and appropriate relationships. : Create all necessary and appropriate relationships.
Rates of exergy transfer accompanying heat transfer : Plot the following quantities, each in kW, versus L ranging from 0.01 to 1 m: the rate of conduction through the rod, the rates of exergy transfer accompanying heat transfer into and out of the rod, and the rate of exergy destruction. Let T0 5 300..
What is the unpaid balance on the current after five years : What hourly charge should be included to pay off the computer, assuming 2,000 hours work per year, credited at the end of year?
Electricity supplied to the water heater : Perform a full exergy accounting, in kJ, of the electricity supplied to the water heater. Model the water as incompressible with a specific heat c 5 4.18 kJ/kg ? K. Let T0 5 23°C.
Completing the gibb and dyches workbook : After completing the Gibb and Dyches workbook, write a summary of at least 150 words for each section (for a total of at least 1,200 words)
What would the total labor cost be : If a team of three workers, each making the U.S. federal minimum wage, produced these 12 rugs, what would the total labor cost be? Don't forget that these workers would be working overtime.
Able to build its dominant position in fast : The total number of pages for this assignment right up to 5 pages only the assignment has to be typed in times roman 12 inches font size and DoubleSpaced you can provide charlottes tables and references after page 5 if the analysis exceed five pa..
Electricity supplied to the water heater : Perform a full exergy accounting, in kJ, of the electricity supplied to the water heater. Model the water as incompressible with a specific heat c 5 4.18 kJ/kg ? K. Let T0 5 23°C.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  A journal bearing is to be designed for a centrifugal pump

A journal bearing is to be designed for a centrifugal pump for the following data: load on the journal = 12 kN ; diameter of the journal = 75 mm ; speed = 1440 r.p.m ; atmospheric temperature of the oil = 16 C ; peering temperature of the oil = 60 C ..

  If a water tank is to be installed on the roof top of the

if a water tank is to be installed on the roof top of the utpa administration building to supply water for the campus.

  Determine temperature of air at the exit

At steady state, air at 200 kPa, 325 K, and mass flow rate of 0.5 kg/s enters an insulated duct having differing inlet and exit cross sectional areas. The inlet cross sectional area is 6 cm squared. At the duct exit, the pressure of the air is 100 kP..

  Refrigerant 134a is throttled from a saturated liquid at

refrigerant 134a is throttled from a saturated liquid at 70f to a saturated liquid-vapor mixture at 36.1 psia. what are

  The tank is heated until its pressure is 100 psia what is a

13 lbm of air inside a rigid tank contains is initially at 100of and 40 psia. the tank is heated until its pressure is

  Assume the drainpipes are the same height as the building

Galvanized iron drainpipes of diameter 50 mm are located at the four corners of a building, but three of them become clogged with debris. Find the rate of downpour (cm/min) at which a single functioning drainpipe can no longer drain the roof.

  The airplane is cruising at m023 with an angle of attack

a flying wing has a swept symmetric airfoil with a planform area of 3700 sq ft a root cord at the airplane centerline

  Calcium silicate has replaced asbestos preferred insulation

Calcium Silicate has replaced asbestos as the preferred insulation for steam lines in power plants. Consider a 40 cm O.D., 4 cm wall thickness steel steam line insulated with a 12 cm thickness of calcium silicate. The insulation is protected from dam..

  Determine a the work developed by the turbine in kj per kg

air at 1175k 8 bar enters a turbine operating as steady state and expands adiabatically to an exit state of 1 bar. the

  Volume operating at steady state with a volumetric flow rate

Steam at 120 bar and 520 ?C enters a control volume operating at steady state with a volumetric flow rate of 460 m3/min. Twenty-two percent of the entering mass flow exits at 10 bar, 220 ?C and a velocity of 20 m/s. The rest exits at another location..

  Material and diameter for the shaft

Suggested material and diameter for the shaft. The material must be a shaft-specific steel. All variables required to purchase both gears: d, Pd, N, F, φ, ψ, etc.

  It is desired to double the efficiency of a carrot heat

it is desired to double the efficiency of a carrot heat engine from 30 by raising its temperatureof heat addition while

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd