Effect of mass ratio on the response of the primary system

Assignment Help Mechanical Engineering

Reference no: EM131143955

Plot an amplification curve ) by using equation (5.39) for ζ = 0.02 after several values of μ (μ = 0.1, 0.25, 0.5, and 1).

Can you form any conclusions about the effect of the mass ratio on the response of the primary system?

Note that as μ gets large, 0(Xk/M₀ )0 gets very small. What is wrong with using very large μ in an absorber design?

Reference no: EM131143955

Questions Cloud

Determine the maximum stress in a coiled rod : Straight rods of 6-mm diameter and 30-m length are stored by coiling the rods inside a drum of 1.25-m inside diameter. Assuming that the yield strength is not exceeded

Perform an investment analysis of a public company : Topic: Financial analysis accounting. Your assignment is to perform an investment analysis of a public company such as Home Depot (HD), Lowes (LOW), Walmart (WMT), etc

Design a broadband vibration absorber : Design a broadband vibration absorber [i.e., equation (5.37)] to limit the machine's motion as much as possible over the frequency range 8 to 12 rad/s.

Determine the largest couple m that can be applied : Knowing that for the extruded beam shown the allowable stress is 120 MPa in tension and 150 MPa in compression, determine the largest couple M that can be applied.

Effect of mass ratio on the response of the primary system : Can you form any conclusions about the effect of the mass ratio on the response of the primary system - What is wrong with using very large μ in an absorber design?

Calculate the optimum damping ratio : Calculate the optimum damping ratio and the frequency at which the damper is most effective at reducing the amplitude of vibration of the primary system.

Why you think the w3c is important in the world of databases : Visit the W3C Web site and look at the information under Mission (http://www.w3.org/Consortium/mission). Discuss why you think the W3C is important in the world of databases.

Determine the radius of curvature of the composite beam : Five metal strips, each 0.5 X 1.5-in. cross section, are bonded together to form the composite beam shown. The modulus of elasticity is 30 X 106 psi for the steel, 15 X 106 psi for the brass, and 10 X 106 psi for the aluminum. Knowing that the beam..

Choose the remaining parameters : The operating speed ranges from 1200 rpm (idle) to 5000 rpm (red line). Choose the remaining parameters so that the whirling amplitude is never more than 1 mm.

User Account

All Pages