Draw the state table and minimize the logic of final circuit

Assignment Help Electrical Engineering
Reference no: EM13287723

Design a 3-bit counter that counts the following sequence:1, 2, 4, 5, 7, 1, 2, etc. This counter has an output"odd" whose value is 1 when the current count value isodd. Use the sequential design technique. Start from a statediagram, draw the state table, minimize the logic, and draw the final circuit.

Reference no: EM13287723

Questions Cloud

Incidence rates for measuring chronic diseases : Why are prevalence rates more useful than incidence rates for measuring chronic diseases?
What averagepower is delivered by the person pulling on rope : A -kg box is being lifted by means of a light rope that is threaded through a single, light, frictionless pulley that is attached to the ceiling, what average power is delivered by the person pulling on the rope
Plot the approximate yield curve of a much riskier lower : plot the approximate yield curve of a much riskier lower-rated company with a much higher risk of defaulting on its bonds.
Crude death rate-cause-specific morbitiy rate for females : In an epidemic in Sample City (population 100,000---60,000 males and 40,000 females), there were 600 cases (350 males, 250 females) of a sever disease. There were 70 deaths (all males) resulting from this disease and 880 deaths resulting from causes ..
Draw the state table and minimize the logic of final circuit : This counter has an output"odd" whose value is 1 when the current count value isodd. Use the sequential design technique. Start from a state diagram, draw the state table, minimize the logic, and draw the final circuit.
What is the expected dollar return on the gamble : Suppose that a person won the Florida lottery and was offered a choice of two prizes: (1) $500,000 or (2) a coin-toss gamble in which he or she would get $1 million if a head were flipped and zero if a tail.
What is the yield on this 5-year corporate bond : A 5-year corporate bond has the same defult risk premium ans liquidity premium as the 10-year corporate bond described. What is the yield on this 5-year corporate bond?
Explain the physical properties and hazards : Several new pieces of equipment are being used in the experiment along with all previous equipment. Using the internet, briefly state why we are using each piece of equipment in this experiment and illustrate with a picture.
Find the charge density of each face of the plate : A square plate of copper with 47.0 cm sides has no net charge, Find the charge density of each face of the plate

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Why does the mobile carrier concentration increases

b) What are the equilibrium electron and hole concentrations at 300K and 500K (hint: You will have to find Nc and Nv at 500K, but it isnt necessary for 300K) c) Why does the mobile carrier concentration increase at high temperatures

  Explain power factor correction

Power factor correction, Three parallel impedances in rectangular form as follows

  Determine the dc self bias line expression relating id to vg

a) By applying Kirchoff's voltage law to the output (DC) circuit loop determine the DC Load Line, i.e. an expression relating Id to Vds. Comment briefly on the significance on the result, with respect to the slope and x-axis intercept.

  What is the characteristic frequency of the combination

An inductance of 8 mH is combined in parallel with a capacitance of 1.5 µF. What is the characteristic frequency (Hz) (not radian frequency) of the combination

  Determine the minimum bandwidth and baud rate

Determine the minimum bandwidth, baud, and bandwidth efficiency for the following bit rates and modulation schemes - 8-QAM and 16-QAM. Fb = 2400 bps Fb = 4800 bps Fb = 9600 bps

  Derive expression for the transconductance characteristic

a) Derive the expression for the transconductance characteristic, gm-vgs, of a JFET. b) Using the expression of the transfer characteristic and the transconductance characteristic, derive formula that expresses the relationship between gm & ip.

  Derive equations for the electric flux density for all ?

Given a coaxial cable with solid inner conductor of radius a, an outer conductor that goes from radius b to c (so c>b>a), a charge +Q that is assumed evenly distributed throughout a meter length of the inner conductor

  Find equivalent of four resistors are connected in parallel

Four Resistors are connected in parallel. what is the equivalent resistance if their individual resistances are  r1 =100 Ohms ±5% tolerance r2 =470 Ohms ±5% tolerance r3 =330 Ohms ±10% tolerance r4 =1000 Ohms ±5% tolerance

  Show that the system has no overshoot in the stepresponse

A causal linear time invariant discrete time system is said to havean overshoot in its step response if the response exhibits andoscillatory behavior with decaying amplitudes around a finalconstant value.

  When to replace zener shunt regulator with an appropriate ic

Desired D.C. Output : 10 V Load Variation: 0.3 kilo-ohms - 10 kilo-ohms Ripple Factor: Less than 0.1% for 2 kilo-ohms load Load Regulation: Better than 3 mV for a 1 mA change in load current

  What are the names of the three regions of the bipolar

What are the names of the three regions of the bipolar junction transistor? Why is there a thin region of one material type

  Determine which instrument is more accurate digital device

A digital device has a decimalindicator showing up to three significant figures. An equivalentanalog device has 1000 divisions over the span. Can we determine which instrument is more accurate Explain.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd