Draw the shift register circuit that would perform the task

Assignment Help Electrical Engineering

Reference no: EM13294531

A CRC is constructed to generate a 4-bit FCS for an 11-bit message.The generator polynomial is X4 + X3 + 1.
a. Draw the shift register circuit that would perform this task.
b. Encode the data bit sequence 10011011100 using the generator polynomial and give the codeword.
c. Now assume that bit 7 in the codeword is in error and show that the detection algorithm detects the error.

Reference no: EM13294531

Questions Cloud

What is the power at which the heater operates : An engineer is developing an electric water heater to provide a continuous ("on demand") supply of hot water. What is the power at which the heater operates

Describe what is the molar mass of the unknown gas : A sample of an unknown gas effuses in 11.9 min. An equal volume of H2 in the same apparatus at the same temperature and pressure effuses in 2.19 min. What is the molar mass of the unknown gas

What is the net force at the top point of the unit circle : On a unit circle with a diameter of 2 m (r=1 m) there are 2 positive charges of 1 C each, one at the center of both sides of the circle. What is the net force at the top point of the unit circle

A huge reservoir of air supplies a converging-diverging : A huge reservoir of air supplies a converging-diverging nozzle with throat and exit areas of 10 cm^2 and 25 cm^2 respectively. The reservoir pressure and temperature are 150 kPa and 20C. Determine the range of back pressure over which

Draw the shift register circuit that would perform the task : A CRC is constructed to generate a 4-bit FCS for an 11-bit message.The generator polynomial is X4 + X3 + 1.a. Draw the shift register circuit that would perform this task.

The corresponding magnitude of r : Two control rods are attached at A to lever AB. Using trigonometry and knowing that force in the right-hand rod is F2=20 lb, determine a.) the required force F1 in the left-hand rod if the resultant R of the forces exerted by the rods on the le..

Obtain the magnitude of the charge on each sphere : Two 1.4 g spheres are charged equally and placed 2.4 cm apart. When released, obtain the magnitude of the charge on each sphere

Plot the capacity of the channel as a function of b : A 10-watt signal is connected to a low-pass channel with bandwidth B Hz. If the channel is corrupted by additive whiteGaussian noise (AWGN) with singel-sided power spectral density of10-7 Watts/Hz.

What is his the finance charge for the period : What is his the finance charge for the period? (Use a table like the one in Exhibit 6.8 for your b.calculations.) Round the answer to 2 decimal places.

User Account

All Pages