Reference no: EM131384174
Draw the front view of the tube bundle support shown in Fig. 18-15. Proceed as follows:
• Draw the outside circle and one of the holes.
• Offset both circles to create the width of the material.
• Draw a line connecting the center of the outside circle and the center of the hole.
• Offset the line to create the internal support structure that connects the hole with the center of the support.
• Draw another line from the center of the large circle at an angle of 30° to the first line.
• Use TRIM to create half of one cavity.
• Use MIRROR to create the other half of the cavity.
• Fillet the three corners.
• Use ARRAY to insert five more copies of the hole and cavity.
When you have completed the drawing, use the SCALE command to shrink it by a factor of .25 using the obvious base point. Save the drawing as tubebundle.dwg.
|
Discuss about the post given below
: Respond to two colleagues (Heath Richards & Thomas Snipes) by refuting or supporting either your colleagues' analysis of the marginalization and oppression of individuals with disabilities or supporting or refuting their analysis of the role of th..
|
|
What are three cautions about using repeated measures anova
: What are three cautions about using the repeated-measures ANOVA.- What is a carryover effect?- Many college students are familiar with meditation exercises. One question about meditation that has been answered is: Are there physiological effects?
|
|
Create a new drawing and draw the kitchen range symbol
: Then enter the ROTATE command and select the four circles and two diagonal lines. After you have completed the rotation, erase both of the diagonal lines. Then scale the range to 25% of its current size. Save the drawing as range.dwg.
|
|
Microwave photonic notch filter
: Microwave photonic (MWP) notch filter can be compared as the analogue of Band stop filter using electrical circuits. As name suggests, it is filter which supress or stop the passage of signal at certain range or specific frequency.
|
|
Draw the outside circle and one of the holes
: Offset the line to create the internal support structure that connects the hole with the center of the support.
|
|
What does this increment determine
: SKETCH requires a Record increment. What does this increment determine? (If you are not sure, specify a relatively large increment such as .5 or 1 and notice the appearance of the sketch lines.)
|
|
Identify what type of error is possible
: In given problem you drew three conclusions based on HSD tests. Each could be wrong. For each conclusion, identify what type of error is possible.
|
|
Find out what the inherit properties button on the hatch
: Find out what the Inherit Properties button on the Hatch and Gradient dialog box does. Explain how it can save you time when you create a complex drawing that has several hatched areas.
|
|
Investigate the gradient tab of the hatch
: Investigate the Gradient tab of the Hatch and Gradient dialog box. What does this tab allow you to do? When might you want to use this feature?
|