Draw the mohr circle representation of the state of stress

Assignment Help Mechanical Engineering
Reference no: EM131377381

For a critical three-dimensional state of stress where, σx = 45,000, σy = 25,000, σz = -50,000, τxy = 4000, τyz = 2000, and τzx = -3500 psi, determine the principal stresses and draw the Mohr circle representation of the state of stress.

Reference no: EM131377381

Questions Cloud

Should mary prevail and why : Later Peter returned with a search warrant and arrested Mary. Mary was charged with various narcotics law violations. Mary asserted the defense of entrapment. Should Mary prevail? Why?
Represent the surface stresses on a mohr circle : Represent the surface stresses on a Mohr circle of an internally pressurized section of round steel tubing that is subjected to tangential and axial stresses at the surface of 400 and 250 MPa, respectively. Superimposed on this is a torsional stre..
What difference between hospital and long term care facility : What are some of the obvious differences between a hospital and a long term care facility that will likely affect health information at this facility?
Should state y lower court have followed ruling of state x : Should the State Y lower court have followed the ruling of the State X Supreme Court until the State Y Supreme Court issued a ruling on the issue?
Draw the mohr circle representation of the state of stress : For a critical three-dimensional state of stress where, σx = 45,000, σy = 25,000, σz = -50,000, τxy = 4000, τyz = 2000, and τzx = -3500 psi, determine the principal stresses and draw the Mohr circle representation of the state of stress.
May professor rabelais challenge given law in state z courts : May Professor Rabelais challenge this law in State Z courts?- May Professor Rabelais challenge this law in a federal district court?
Profit maximizing price-quantity combination for monopolist : Suppose that firms’ marginal and average costs are constant and equal to c and that inverse market demand is given by P = a – bQ, where a,b>0. Calculate the profit maximizing price-quantity combination for a monopolist. Also calculate the monopolist’..
Obtain jurisdiction against diem for damages : Butt would like to know if he personally serves the proper papers to Diem whether he can obtain jurisdiction against Diem for damages in the given courts:
Calculate the maximum shear stress : Also, calculate the maximum shear stress and draw the Mohr circle representation of the state of stress at the critical point.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  What is the height of a column of water

What is the height, in m, of a column of water at 10°C equivalent to a pressure of two atm

  Where are the respective reference points of particles

Two particles A and B start from rest at the origin s=0 and move along a straight line such that a_A=(6t - 3) ft/s^2 and a_B=(12t^2 - 8) ft/s^2, where t is in seconds. Where are the respective reference points of particles A and B? What are the direc..

  A simplified analysis is applied to gas turbine engine cycle

A simplified analysis is applied to a gas turbine engine cycle that has a compression ratio of 8 to 1. The compressor and turbine inlet temperatures are, respectively, 300 K and 1400 K. Values of gas (air) properties are obtained from the Air-gas tab..

  Comfortable skin temperature

Consider the conditions of Example 3.12 for an air environment, except now the air and surroundings temperatures are both 15°C. Humans respond to cold by shivering, which increases the metabolic heat generation rate. What would the metabolic heat ..

  Determine the reactions on the beam

Determine the reactions on the beam at its support A in terms of the compression CA, shear VA, and bending moment MA.

  Determine the pressure drop across the contraction section

water flows at a rate of .04 m3s in a .12 meter diameter pipe that contains a sudden contraction to a .06 m pipe.

  Draw a cash-flow diagram

Major overhaul expenses of $5,000 each are anticipated for a large piece of earthmoving equipment. The expenses will occur at EOY four and will continue every three years thereafter up to and including year 13. The interest rate is 12% per year.

  Determine a the principal stresses on an element from the

a thin-walled closed-end cylindrical pressure vessel with spherical end caps is internally pressurized to 500 psi. if

  What is the maximum isolator stiffness of undammed isolator

A 1000 Kg machine has rotating unbalance of 0.1 kg-m. It operates a speed of 500 to 750 rpm. What is the maximum isolator stiffness of undammed isolator that can be used to reduce the transmitted force to 300 N at all operating speeds?

  Determine the values of the constants

Determine the values of the constants A and σ o for the material. [Remember that the tensile strength is the maximum engineering stress.]

  Determine the total number of air conditioning

There are about 35 light bulbs in the room, each with a rating of about 40 W.  The rate of heat transfer through the walls and windows to the room will probably be around 15,500 kJ/h.  Determine the total number of air conditioning units needed to..

  A piston-cylinder device contains 25 kg of air at 150 kpa

a piston-cylinder device contains 2.5 kg of air at 150 kpa and 2 m3. the air is now compressed according to the

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd