Draw the influence line for the shear at point b

Assignment Help Civil Engineering

Reference no: EM13542301

1.Using the principle of transmissibility, the force F_evec can be slid along its line of action from point A to any other point along its line of action. What points along the line of action of the force F_evec would simplify the calculation of M, the magnitude of the total moment due to the force F_evec about point O?

2.Draw the influence line for the shear at point B. Plot numerical values every 5 ft. Assume the support at A is a roller and C is fixed. EI is constant.

3.Steam at 800 kPa and 300 C is bled off from a large supply line, passed through a valve, and allowed to enter an initially evacuated, uninsulated tank with a volume of 0.3 m3. When the pressure in the tank reaches 100 kPa, the valve is closed. The temperature in the tank when the valve is closed is reported to be 150 C. Determine whther this process is possible (Assume T0=25 C).

Reference no: EM13542301

Questions Cloud

When the pressure in the tank reaches the valve is closed : Steam at 800 kPa and 300 C is bled off from a large supply line, passed through a valve, and allowed to enter an initially evacuated, uninsulated tank with a volume of 0.3 m3.

Apply corrections for temperature pull and sag to determine : What is the water content and liquidity index of the fines in compacted mass?A civil engineer used a 30-m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20 m long.

Calculate the linear density of atoms in these directions : For FCC diamond cubic structures, give the lattice coordinates for the atoms found in the [100], [110], [111] direction? and Calculate the linear density of atoms in these directions for Ge.

Determine the correct horizontal distance considering : A civil engineer used a 30-m tape in measuring an inclined distance. The measured length on the slope was recorded to be 459.20 m long. The difference in elevation between the initial and the end point was found to be 1.25 m

Draw the influence line for the shear at point b : Draw the influence line for the shear at point B. Plot numerical values every 5 ft. Assume the support at A is a roller and C is fixed. EI is constant.

Determine the shear force and bending moment diagrams : A wood mallet has a cylindrical head 6 inches long and 3 inches in diameter. If the cylindrical head is 1 inch in diameter how long must it be for the mallet to balance at a point 6 inches from where the handle enters the mallet? (use 40 lb / ft cube..

What rate of perspiration would be needed to maintain a : Considere a person who consumes 2100 kcal par day, of which 2000 kcal is converted thermal energy.( the remaining 100 kcal is used to do work on the environment.) The person has a surface area of 1.8 m² and is dressed in a bathing suit.

Should the company proceed with the process change : The company Eco-Safe is adding pollution control equipment to its process and reducing emission of pollutants. The annual waste disposal cost of the current process is $130,000 and the annual operating cost is $600,000

Determine the viscosity of the fluid : Two parallel plates are separate at a distance of 2mm by a fluid. If a shearing stress of 150 Pa is developed at the upper plate when it is pulled at a velocity of 1m/s. Determine the viscosity of the fluid.

User Account

All Pages