Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Make a layout drawing showing a suitable mounting arrangement for the gear and bearing housing mounted on the mounting surface shown in Fig. 20-46. The design is for low-speed moderate use. Draw the gear and one shaft support in full section, and the pulley and the other shiut support in half section. A partial top view is required to show the location of the mounting holes. Standard parts are to be used wherever possible, and an item list is to be included on the drawing. Scale 1:1.
Describe one practical application that uses an adder - What is a major advantage of using two's complement subtraction?
Two-wattmeter method is used to measure the power absorbed by a 3-phase induction motor.- Find the power absorbed by the machine. - Find load power factor.
a sound distribution system has the following outputs 10 watts at 8ohms,5watts at 4 ohms, 15 watts at 16 ohms and 2 watts at 4 ohms if the input to the amplifier is 20 millivolts at 600 ohms how much gain in decibels will be required of the amplif..
a 9.1 v zener diode exhibits its nominal voltage at a test current of 28 mA . at this current the incremental resistance is specified as 5 ohms . find Vz0 of the zener model . find the zener voltage at a current of 10 mA and at 100 mA.
If the capacitor in the previous problem has a plate separation of 1 mm, what is the average displacement current, to the nearest tenth of a microamp, during that time period Assume a resistance of 180006 ohms and an applied voltage of 14 volts.
A 6-V voltage regulator is rated to have a load regulation of 2% for a maximum load current of 20 mA. Assuming a no-load output voltage of 5.9 V, what is the worst-case output voltage at the maximum load current?
a 20 mH inductor with an internal resistance of 20 ohms is connected in series with a capacitor and a voltage source with a thevenin resistance of 60 ohms. a. what value of C will be needed to produce Wo = 6 krad/s
A two-stage amplifi er has these stage gains: Av1 =25.8 and Av2 =117. What is the decibel voltage gain of each stage? The total decibel voltage gain?
What is the "frame rate" of the time-dependent Fourier analysis; i.e., how many DFT computations are done per second of input signal
In the circuit of Figure, prove that the gain from the noise voltage of each resistor to the VCO output frequency is equal to KVCO.
What is the (approximate) maximum electric field intensity for which constant mobility may be assumed for electrons in silicon. In a digital circuit with a supply voltage of 1V, what is the corresponding gate length for MOS transistors.
Using the cost analysis presented in the text, perform a parametric study to determine the optimum diameter of a pipe if the flow rate and the length are imposed.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd