Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Propane gas enters a continuous adiabatic heat exchanger' at 40°C and 250 kPa and exits at 240°C superheated steam at 300°C and 5.0 bar enters the exchanger flowing counter currently to the propane and exits as a saturated liquid at the same pressure.
(a) Taking as a basis 100 mol of propane fed to the exchanger, draw and label a process flowchart. Include in your labeling the volume of propane fed (m3), the mass of steam fed (kg), and the volume of steam fed (m3).
in a crank or slotted lever quick mechanism the distance between the fixed centre is 150 mm and driving crank is 75 mm. determine the ration of the time taken of cutting & return strake .
Examine the influence of the vibration on the grain size, microstructure and mechanical properties of aluminium-silicon alloys (Al-Si) during solidification.
Mechnical Vibration Analysis, How do I deduce the value of the viscous damping factor? How do I deduce the value of the viscous damping coefficient c?
What is the discharge revised discharge pressure (guage pressure) of the compressor ? Is the assumption of change in temperature valid for calculating the discharge pressure of the compressor ?
this would provide you with a set of Reynolds numbers. Next, using the integral method, determine the velocity profiles within the boundary layer to be followed by determination of the heat transfer coefficient values for your selected Reynolds numbe..
Determine the COP of the heat pump that applies energy to a house at a rate of 4500kj/h for each kW of electric power it draws. Also, determine the rate of the energy absorption from the outdoor air.
Centrifugal Clutch Question, In a centrifugal clutch there are eight shoes, each of mass 0.3 kg and the centre of gravity of each shoe is at 50 mm radius when it is just touching the drum of diameter 200 mm.
Principles of Engineering Economic Analysis-Time value of money-use of gradient factor is expected
Analysis of the motion of swing including velocity and acceleration plots of all moving parts and projectile analysis of projectile eg: flight path, horizontal distance, deceleration and launch velocity
The maximum flow past a circular cylinder is 2 X the Up stream velocity. The max velocity occurs at the center line of the top of the cylinder.
A jack-screw has a handle 35 inches long and a pitch of 7/32 inches. If a pull of 15 lbs. is required at the end of the handle to lift a 3,000 lbs.
Determine (a) the exit temperature, (b) the exit relative humidity of the air, (c) the exit velocity.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd