Doug have to open the door before the 800 mg

Assignment Help Civil Engineering
Reference no: EM13552862

Doug decides to use a turkey fryer to prepare the Thanksgiving turkey. Due to cold weather, he prepares the turkey with the door closed, limiting air exchage (Q) within the 40 m3 garage to 0.2 m3 min-1. If the fryer emits 350 mg min-1 of CO, a conservative chemical, how long does Doug have to open the door before the 800 mg m-3 fatality limit is surpassed? Assume an initial CO level of zero and that any air entering the garage is CO-free.

Reference no: EM13552862

Questions Cloud

Evaluate the rates of linear and angular deformation : Consider the pressure-driven flow between stationary parallel plates separated by distance 2b. Coordinate y is measured from the channel centerline. The velocity field is given by u=u max(1-(y/b)^2).
How many pounds of coal must be burned to keep one 100 watt : How many pounds of coal must be burned to keep one 100 watt light bulb lit for one hour? Assume efficiency of the power plant is 35%, the transmission losses are 10% fo the delivered poer, and the heating value of coal is 12,000 BTU/lb
Calculate the nominal and the effective rate of return : A 10-year, 12%, $1,000 bond that pays dividends quarterly can be purchased for $900. If the bond is purchased and pays as scheduled, calculate the nominal and the effective rate of return that the purchaser receives.
You have found a great place to pitch your tent 200 m direct : A bonfire emits CO at a rate of 30 g/s on a clear night (very stable conditions, Class F). The wind is blowing at 2 m/s at the effective stack height of 6 m. a. You have found a great place to pitch your tent 200 m directly downwind of the fire
Doug have to open the door before the 800 mg : Doug decides to use a turkey fryer to prepare the Thanksgiving turkey. Due to cold weather, he prepares the turkey with the door closed, limiting air exchage (Q) within the 40 m3 garage to 0.2 m3 min-1
Compute the percent change n in the normal forces at a and b : During an engine test on the ground, a propeller thrust T = 4000 N is generated on the 1500 kg airplane with mass center at G. The main wheels at B are locked and do not skid; the small tail wheel at A has no brake.
Record any necessary journal entries in 2010 : Record any necessary journal entries in 2011 relative to 2010 television warranties.
Do you believe it is plausible that the blocks do not meet : Do you believe it is plausible that the blocks do not meet the specification, or are you convinced that the blocks meet specification? Explain your reasoning.
Particularly important to financial statement users : Particularly important to financial statement users.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Estimate the overall dimensions

Provide a reasonable design for a 99.4% efficient ESP treating 30,000 m^3/min of gas. The dust has a resistivity of 7.1 (10)^10 ohm-cm. Specify the total plate area, channel width, number and size of plates

  What is the level of service of the upgrade segment

On this segment of freeway, the directional peak-hour volume is 3800 vehicles with 2% large trucks and 4% buses (no recreational vehicles), the peak-hour factor is 0.90, and all drivers are regular users.

  Determine the net power output of the engine

The cycle has a thermal efficiency of 35%, and steam changes from saturated vapor at 300 C during the heat addition process. If the mass flow rate of the steam is 2kg/s, determine the net power (kw) output of this engine.

  Establish a grass cover over a 10ha landfill the root zone

establish a grass cover over a 10ha landfill. the root zone of the grass is 40cm deep. increase the volumetric water

  What is the hydraulic residence time of the reactor

Average flow rate = .0022 m^3 /s (190 m^3 /d) Influent Substrate concentration = 250 mg/L as COD (all essentially soluble) Mean cell residence time is to be 5 days Volume of mix tank

  Determine what is the hydraulic conductivity of the material

Water seeps vertically downward from the bottom of a lake through a uniform material to an aquifer below. The discharge is 0.005 ft^3/s through a 1 ft^2 area of the lake bottom.

  Determine depth result upstream during design flood event

A 1.5m diameter barrel (concrete barrel, well-rounded entrance) that is 20 m long is installed on a slope of 2 percent. The design discharge is 9.5 m^3/s and the inlet will be submerged but not the outlet.

  At what temperature will the rails touch end to end

The steel rails of a continuous, straight railroad track are each 60 ft long and are laid with spaces between their ends of 0.25 inches at 70 degrees F. At what temperature will the rails touch end to end

  Standard deviation in lines of levels

Lines of levels were run requiring n instrument setups. If the rod reading for each backsight and foresight has a standard deviation δ what is the standard deviation in each of the following level lines?

  Design the column including cross-sectional dimensions

A tied short column of square cross-section is subjected to a factored axial load of 2500 kN and a factored bending moment of 175 kN.m. Use a 40 mm clear cover to the ties and a 20 mm maximum aggregate size.

  What is the reduction in oc for the exhaust temperature

Engineers at the General Electric turbine division are trying to improve an existing adiabatic steam turbine that receives 100 kg/s superheated steam at 10 MPa and 800 oC and after expansion and producing power,

  Find the required minimum area for the heat transfer neglect

Saturated liquid water at 1000 kPa flows at 2 kg/s inside a 10 cm outer diameter steel pipe and outside of the pipe is a flow of hot gases at 1000 K with a convection coefficient of h = 150 W/m2 K

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd