Does the spectrum looks like single side band

Assignment Help Electrical Engineering
Reference no: EM132676524

ECE 44000 Transmission of Information - Purdue University

Lab - Amplitude Modulation

Section 1: DSB-SC Simulink

This lab is a follow up from previous lab. You need to demonstrate similar modulation scheme using Simulink.
Use the same parameters from lab 4.
Use 100 kHz for the sampling frequency as you had in Lab 4.
In Simulink, obtain the spectrum analyzer plots of DTMF signal
Using DSBSC AM Modulator block, obtain the scope of DTMF signal and modulated DTMF signal. Also obtain the spectrum analyzer plot of modulated DTMF signal. (8 points).
Demodulate the signal using DSBSC AM Demodulator block with low pass filter cut off frequency of 20kHz. Obtain the spectrum analyzer plot of demodulated DTMF signal. Also obtain the time scope signal of original signal and demodulated signal .
Repeat the demodulation scheme above but change the low pass filter cut off frequency to 5kHz. Obtain the spectrum analyzer plot of demodulated DTMF signal. Also obtain the time scope signal of original signal and demodulated signal .

ADDITIONAL INSTRUCTIONS:
Make sure scope plots are zoomed in and show no more than 5ms of data
Use peak finder to identify all the frequency peaks.
Assume 50 Ohms Spectrum analyzer load.
Make sure to have your spectrum analyzer settings configured to show only one sided spectrum (positive frequency only).

Answer the following questions:
Based on what was taught in lecture session, how many peaks of demodulated signal do you expect to see? Do you see the same number of peaks in your result? If there are more peaks than expected, indicate which are going to give significant contributions.
Is the demodulated signal in phase with the original message? Why is there phase change?
Which low pass filter cut off should you use? 5kHz or 20kHz? Explain why?
What is the bandwidth of the message?
What is the bandwidth of the modulated signal?

Section 2: SSB Simulink

For either upper sideband modulation or lower sideband modulation, answer the following questions:
Does the spectrum looks like single side band or double side band modulation? Explain why! Identify which of the peak(s) have significant contribution? (You need to convert dBm into Watts and show why you choose the peaks). Is this expected? Explain
What is the bandwidth of the message?
What is the bandwidth of the modulated signal?
What are the main advantage of SSB over DSB modulation?

Random Variables - Amplitude Modulation

1. Based on what was taught in lecture session, how many peaks of demodulated signal do you expect to see? Do you see the same number of peaks in your result? If there are more peaks than expected, indicate which are going to give significant contributions.
2. Is the demodulated signal in phase with the original message? Why is there phase change?
3. Which low pass filter cut off should you use? 5kHz or 20kHz? Explain why?
4. What is the bandwidth of the message?
5. What is the bandwidth of the modulated signal?

Does the spectrum looks like single side band or double side band modulation? Explain why! Identify which of the peak(s) have significant contribution? (You need to convert dBm into Watts and show why you choose the peaks). Is this expected? Explain
What is the bandwidth of the message?
What is the bandwidth of the modulated signal?
What are the main advantage of SSB over DSB modulation?

Reference no: EM132676524

Questions Cloud

Find the lower-of-cost-or-market valuation for company : Find the lower-of-cost-or-market valuation for company's inventory. Oriole Company accumulates the following cost and market data at December 31.
What are the main causes of symptoms : YakkaTech Ltd. is an information technology services firm employing 1500 people across Canada. YakkaTech has a consulting division, which mainly installs
Determine what is the cost of the truck : Cullumber Company incurs these expenditures in purchasing a truck, accident insurance (during use) $2,310. What is the cost of the truck?
Calculate the effective yearly return over the year period : Calculate the effective yearly return over the 5 year period. 5 yr loan of $200 000 for a $400 000 bike shop. ($200 000 is from own investment)
Does the spectrum looks like single side band : Does the spectrum looks like single side band or double side band modulation? Explain why! Identify which of the peak(s) have significant contribution?
Compute the lower-of-cost-or-market valuation for company : Compute the lower-of-cost-or-market valuation for company's inventory. Oriole Company accumulates the cost and market data at December 31.
Difference between pension and postretirement benefits : What is the difference between pension and postretirement benefits?
What is the nexus of contracts view of the firm : Describe how accounting information is used in contracts between the shareholders and management. What is the nexus of contracts view of the firm?
What impact can role models have on success : Learning and school and succeeding can hold such a powerful impact on success in the future of students.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Compute the irr

In the architecture of Fig., assume the two resistors have a mismatch of R. Compute the IRR.

  Determine the emf induced in one coil

The mutual inductance between two coils is 0.15 H. Determine the emf induced in one coil when the current in the other decreases uniformly from 5 A to 3 A, in a time of 10 ms.

  Research paper on the benefits of electromagnetic fields

Research Paper on the Benefits of Electromagnetic Fields in Society (medical industry, science, devices etc.)

  Derive an expression for the resonant frequency

Derive an expression for the resonant frequency of a Fabry-Perot resonator having a plate separation d and mode number

  Design a two position controller with trip points

It has a 5-mW/°C-dissipation constant. Design a two-position controller with trip points of 35°C and 60°C. Keep self-heating below 0.5°C.

  Design circuit using binary counter that sequentially counts

Using a 74LS169, 74LS47, and a Seven Segment Display, design a circuit using a binary counter that sequentially counts from 0 through 9 and displays the count on an LED. When the count reaches 9 the counter should reset to 0 and begin the count ag..

  Design a wien bridge oscillator

Design a Wien bridge oscillator and proof that the bridge attenuetes the operating frequency signal by a third.

  Calculate field on one side of disk as function of distance

Consider a thin ring of radius a with uniform charge density and total charge Q. The ring is cut in half across the diameter and the two halves superimposed to double the effective charge density.

  What is the difference between neutral, ground and earth

What is the Difference Between Neutral, Ground and Earth?

  What is the energy cost if the motor ran for an hour

an 8 pole synchronous motor produces a full load torque of 25 foot pounds, fed from a 60hz source and is now operating at 60% eff. What is the energy cost if the motor ran for a 8000 hrs/yr and the electrical energy cost were $.09/kWh.

  Draw an adjacency diagram for the original flow table

A flow table is given in Figure 2 below. Find an assignment of state variables that avoids all critical races. You may add additional states as necessary (using a few state variables as possible). Assign the all-0s combination to state A. Draw an a..

  Find the deformation gradient in terms of gx2

Find the deformation gradient in terms of g(X2).- If the volume of the beam does not change, find g(X2).- Using g(X2) in (b), find U, Q, and V.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd