Does the current process appear to be in control

Assignment Help Operation Management

Reference no: EM131931295

Quality Control Analytics at Toyota

Answer in Excel, see templete below:.

As part of the process for improving the quality of their cars, The car engineers have identified a potential improvement in the process that makes a washer that is used in the accelerator assembly.

The tolerances on the thickness of the washer are fairly large since the fit can be loose, but if it does happen to get to large, it can cause the acelerator to bind and create a problem for the driver.

Let's assume that, as a first step to improving the process, a sample of 40 washers coming from the machine that produces the washers was taken and the thickness measured in millimeters. The following table has the measurements from the sample:

1.9 2.0 1.9 1.8 2.2 1.7 2.0 1.9 1.7 1.8

1.8 2.2 2.1 2.2 1.9 1.8 2.1 1.6 1.8 1.6

2.1 2.4 2.2 2.1 2.1 2.0 1.8 1.7 1.9 1.9

2.1 2.0 2.4 1.7 2.2 2.0 1.6 2.0 2.1 2.2

Questions

1. If the specification is such that no washer should begreater than 2.4 millimeters, assuming that the thick-nesses are distributed normally, what fraction of the output is expected to be greater than this thickness?

2 If there are an upper and lower specifi cation, wherethe upper thickness limit is 2.4 and the lower thick-ness limit is 1.4, what fraction of the output is expected to be out of tolerance?

3 What is the Cpk for the process?

4 What would be the Cpk for the process if it were centered between the specification limits (assume the process standard deviation is the same)?

5 What percentage of output would be expected to be out of tolerance if the process were centered?

6 Set up __ X - and range control charts for the current process. Assume the operators will take samples of 10 washers at a time.

7 Plot the data on your control charts. Does the current process appear to be in control?

8 If the process could be improved so that the standard deviation were only about .10 millimeter, what would be the best that could be expected with the processes relative to fraction defective?

Reference no: EM131931295

Questions Cloud

Briefly describe the qualities of good writing : Briefly describe the qualities of good writing.

What are the total carrying costs : ABC Company sells 3,531 chairs a year at an average price per chair of $157. The carrying cost per unit is $30.42.

Find the total cash flow you will have three years : Find the total cash flow you will have 3 years from now if interest rates decrease to 19% just after you buy the bond,

What is the cost of it is preferred : ABC bank has an issue of preferred stocks with a $1.5 annual dividend per share. It's quoted at $30 per share. ABC wants to sell more preferred to raise capital

Does the current process appear to be in control : What percentage of output would be expected to be out of tolerance if the process were centered?

Discuss the economic order quality model : ABC Company sells 3, 622 chairs a year at an average price per chair of $179. The carrying cost per unit is $59.14. The company orders 596 chairs at a time.

Describe the macrs allowance percentages : ABC Company purchased $138,075 of equipment 5 years ago. The equipment is 7-year MACRS property. The firm is selling this equipment today for $10,782.

Key elements of an effective introduction : What are the key elements of an effective introduction? Where should the thesis be placed? Why?

How do they function differently in story : In "A Very Old Man With Enormous Wings" by Garcia Marquez, compare and contrast the two "magical" characters, the man with the wings and the girl

User Account

All Pages