Dispute resolution methods

Assignment Help Business Law and Ethics

Reference no: EM13703066

Question :1. Choose 2 dispute resolution methods for each of your scenarios fromthe following list. Some of these are described in the Astor and Chinkin reading(some have been left out intentionally and some are also known by different names). Giving reasons relating their advantages and disadvantages found in your research, state which might be preferred for each particular scenario:

a. Litigation
b. Mediation
c. Expert Appraisal and Determination
d. Case Presentation
e. Conciliation
f. Arbitration

Question :2. You may use each resolution process only once in your assignment.

Reference no: EM13703066

Questions Cloud

Nonqualified deferred compensation : What is meant by the term nonqualified deferred compensation for income tax purposes, and for whom is it most often used - Discuss the applicability of IRC Section 409(a) to each plan.

Decide the amount of heat transfer from the air : 500kg of air at 35 degrees Celsius dry-bulb and 20 degrees Celsius wet-bulb temperatures is cooled to 13 degrees Celsius dry-bulb and 90% relative humidity. Decide the amount of heat transfer from the air in MJ

What is the largest diameter the steel shaft : A brittle cast iron (E = 15 Msi, ? = 0.2, Sut = 30 ksi, Suc = 100 ksi) hub is shrink-fit onto a solid carbon steel shaft. The hub has initial inner and outer diameters of 3.000 and 6.000 inches respectively. What is the largest diameter the steel sha..

Completely drill out the crack with hole : A long rectangular bar 20 mm wide and 10 mm thick made of hot-rolled 4340 carbon steel (Sy = 860 MPa, K1c = 99 MPaÖm), is found to have a centrically located through-thickness crack 8mm wide. Is it best to a) leave the crack alone, b) drill a 5 mm di..

Dispute resolution methods : Choose 2 dispute resolution methods for each of your scenarios fromthe following list. Some of these are described in the Astor and Chinkin reading

Determine the input power in watts : A motor has a disk mounted on its shaft. The disk has a diameter of 1 foot and weighs 60 pounds. Starting from rest, the motor rotates at 350 rpm after 5 seconds. If the motor has a 92% efficiency, determine the input power in watts.

Determine the pressure at the turbine exit : A turbojet is flying with a velocity of 900 ft/s at an altitude of 20,000 ft, where the ambient conditions are 7 psia and 108F. The pressure ratio across the compressor is 13, and the temperature at the turbine inlet is 2400 R.

Natural gas having a molar analysis : Natural gas having a molar analysis of 60% methane (CH4) and 40% ethane (C2H6) enters a compressor at 340K, 6 bar and is compressed isothermally without internal irreversibilities to 20 bar. The compressor operates at steady state, the kinetic and po..

Dispute resolution : A group of neighbours in your area are fed up with a house of uni students who continue to have late night parties, disrupting the neighbourhood. You and your neighbours want to take action.

User Account

All Pages