Discuss the advantages and disadvantages of 8-bit adc

Assignment Help Civil Engineering
Reference no: EM13310172

Discuss the advantages and disadvantages of using 8-bit and 10-bit resolution for the analog-to-digital converter.

Reference no: EM13310172

Questions Cloud

What would be the magnitude of the current in the diode : You put a diode in a microelectronic circuit to protect the system in case an untrained person installs the battery backward. what would be the magnitude of the current in the diode
Find percentage of air voids and voids in mineral aggregates : Find the percentage of Air voids and voids in the mineral aggregate if the asphalt absorption is .5%, and the specific gravities of the aggregate and binder are 2.660 and 1.020 respectively. The unit weight of the mixture is 2.39 Mg/m^3
What are the top three factors that you improved during : The Briargrove Project has successfully completed multiple phases within the corporate offices. The project is prepared to move into remote offices across the organization. In your paper address the 4 key stages of project monitoring and how that wil..
What are two types of variables that can be used for values : What are two types of variables that can be used for values that are less than 128, and describe what is the difference between the variables, how to declare them, and the memory allocated and the numerical range for both.
Discuss the advantages and disadvantages of 8-bit adc : Discuss the advantages and disadvantages of using 8-bit and 10-bit resolution for the analog-to-digital converter.
Find what is the op amp output voltage with a digital input : The reference current for the DAC0808 is 2.0 mA. With the DAC output connected to the inverting input of an op amp with a feedback resistor of 5.0 kohms, what is the op amp output voltage with a digital input of 0x80
Explain what is the strongest bronsted-lowry acid : What is the strongest Bronsted-Lowry acid in the chemical reaction shown below. 2 HNO3 (aq) + Ba(OH)2 (aq) ---> Ba(NO3)2 (aq) + 2 H2O (l) a) HNO3 b) Ba(OH)2 c) Ba(NO3)2 d) H2O
What i have wrote in my proposal : I have my proposal ready, but what I need someone gets it done for me. My Prof. is tough about the plagiarism and what I have wrote in my proposal.
Find the horizontal coordinate of the center of gravity : The track is 10.00 cm wide, 5.00 m long, and 2.78 m high, and is solid. The runway is cut such that it forms a parabola by the equation y = (x - 5)2 / 9

Reviews

Write a Review

Civil Engineering Questions & Answers

  What is the average degree of consolidation for clay layer

A normally consolidated clay layer is 4 m thick (one way drainage). From the application of a given pressure, the total anticipated primary consolidation settlement will be 80mm. What is the average degree of consolidation for the clay layer.

  Determine the required length of superelevation runoff

A simple highway curve is planned to connect two horizontal tangents that intersect at sta. 2500+00.00 at an external angle of 52°. For a design speed of 60 mi/h and a curve radius of about 1.25 times the minimum allowable

  Determine what was the major principal stress at failure

A consolidated-drained triaxial test on a normally consolidated clay yielded a friction angle of 28°. If the all-round confining pressure during the test was 140 kN/m2, what was the major principal stress at failure.

  Determine which equation is valid in any system units

According to information found in an old hydraulies book, the energy loss per unit weight of fluid flowing through a nozzle connected to a hose can be estimated by the formula h=(0.04 to 0.09)(D/d)^4*V^2/2*g

  How much distance must be cleared from the center of lane

If the superelevation is .10 at the station of the PC is 17+35, what is the station of the PI and how much distance must be cleared from the center of the lane to provide adequate stopping sight distance

  Find the probability that temperature exceeds 58 degree f

The following data are the temperatures (in °F) of effluent at discharge from a sewage treatment facility on consecutive days: 43 47 51 48 52 50 46 49 45 52 46 51 44 49 46 51 59 45 44 50 48 50 49 50

  Determine annual volume of solid waste produce by source

the bailey stone works employs six people. assumming that the density of uncompacted waste is 480 kg/m^3, determine the annual volume of solid waste produce by the stone works assumming a waste generation rate of 1 kg/cap*d.

  Find the magnitude of the particles position and velocity

The position of a particle P moving in the horizental plane is described by r(t)= (5t^2 i +2te^0.1t j) m. Find the magnitude of the particle's position, velocity, and acceleration at time t=2 sec.

  How many feet below railway should curve pvi be located

An existing high-way railway at-grade crossing is being redesigned as a grade seperated to improve traffic operations. the railway must remain at the same elevation. the highway is being reconstructed to travel under the railway.

  Determine a soil with a hydraulic conductivity and depth

Is a soil with a hydraulic conductivity of 1*10-5 cm/s and depth of 10 ft equivalent to a soil with hydraulic conductivity of 1*10-6 cm/s and depth of 5 ft

  Determine what is the outlet air temperature

A total of 13,610 kg/h of air at 1 atm abs pressure and 15.6C is to be heated by passing over a bank of tubes in which steam at 100C is condensing. The tubes are 12.7mm OD, 0.61 m long, and arranged in-line in a square pattern with Sp=Sn= 19.05mm.

  Where the maximum ground level concentration would occur

a power plant burns 150,000 tonnes (1 tonne = 1,000 kg) of coal each year. The coal has 2.5% sulfur content, and the air pollution control equipment removals approximately 94% of sulfur. Assume 10% of the sulfur content ends up in the ash.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd