Discuss symmetrical conditions in fourier series

Assignment Help Electrical Engineering
Reference no: EM131246202

ASSIGNMENT

1. Discuss symmetrical conditions in Fourier series

2. Derive conversion formulae among different types of Fourier Series

3. State and prove any six properties of Fourier transform.

4. State and prove any four properties of Laplace transform.

5. Short notes on following

a) Energy signal- power signal b) LTI system c) Casual system d) Dirichlet's conditions e) Completeness f) Harmonic Signals g) Final value and initial value theorems in Laplace transformation h) Bandwidth of Periodic and aperiodic signals

i) ESD and PSD

6. For the given periodic signal find exponential Fourier series and trigonometric Fourier series.

1066_Figure.jpg

7. Find the Fourier transform of the signals and also Sketch phase and magnitude spectrums

a)

2458_Figure1.jpg

b) v(t) = (Sin t) (Cos t)/t and

c) g(t) = 4 rect [(3t-2) /T]

8. Find Laplace transforms of signals

a) t2 sin (at) u(t)

b) Causal Periodic signal

9. Define Impulse response? If impulse response is h(t) = 4 e-2t +3e-2t cos (8t), then comment on stability and causality of the system.

10. FT of periodic signals

11. The input for an LTI system with transfer function H(s) = 1/(S+1) is e-2t u(t), then find output?

12. Draw graphs of the signals, f(t) = 5rect[(4t - 3)/-8], Sin[u(t)] and δ(sint)

13. Write short notes on
i. Parseval's theorem
ii. Region of convergence
iii. Existence conditions of FT and LT

14. Discuss the concepts of Linear, Causal, Stable and Time invariant for continuous systems

15. A continuous-time signal x(t) is shown below. Plot x(2-t) and x(t/2).

406_Figure2.jpg

16. Prove that if x(t) ↔ x(w) then x(at) ↔ 1/|a|x(w/a)

17. Plot the amplitude spectrum of x(t) = 5 cos(2πt).

18. State whether the signal x(t) = Ae3t is a power signal or energy signal. Justify your answer.

19. Prove that δ (at) = 1/|a|δ(t).

20. Find the Fourier transform of the signals
i) x(t) sin(wot)
ii) x(t) = δ (t + to) + δ (t-to)

21. Find the trigonometric Fourier series for the waveform shown in figure.

2145_Figure3.jpg

22. Sketch the following signal, where r(t) is ramp signal.

r(t) - 2r(t - 2) + r(t - 4).

23. Find the Laplace transform of the signal

x(t) = e-a|t| and find its ROC

24. Find the Fourier transform of e-at u(t).

25. Give the effect of time scaling and time shifting on the signal x(t)= cos 3w0t.

26. Determine whether the following system is stable or not.

h(t) = 5e-2tu(t)

27. If x(t) = δ'(t+3) -3δ(t-3) + 4δ(t+2) then sketch g(t) = -a+a x(t)dt

28. If x(t)=cos(Π/3 t) + sin(Π/4t) is x(t) periodic, if periodic find the period of x(t).

29. Find the Laplace transform of x(t) = e-atu(-t).

30. If x(t) =  { 1      |t| < a       obtain the Fourier transform of x(t)

                    { 0      otherwise

31. If X(ω) = jd/dw {ej2ω / (1+ jω/3) } is the Fourier transform of a signal x(t), then find the signal x(t)

32. Consider a continuous time linear time invariant system for which the input x(t) and output y(t) are related by [d2y(t)/dt2] +dy(t)/dt - 2y(t) = x(t)

(a) Find the system function

(b) Determine the impulse response

33. (a) Determine the 90% energy containment of Bandwidth of the signal

x(t) = 1/ (t2 + a2)

(b) Find the initial and final values of the signal x(t) whose Laplace transform

X(s) is 10(s+4) / (s+2)(s2-2s+2)

34. A signal x(t) is shown in figure below, sketch x(t)u(1-t).

803_Figure4.jpg

35. A periodic signal x(t) is shown in figure below. Find FT X(w)

1612_Figure5.jpg

36. If x(t)= 1/( a2 + t2) Find the Fourier transform of x(t).

37. If x(s) = (s2 + 6s +7) / (s2 + 3s +2) Re(s)≤1, is the Laplace transform of x(t), obtain the inverse Laplace transform.

38. Prove that cos( mω0t) and sin( nω0t) are orthogonal to each other. Where m and n are integers (‘m' and ‘n' are not equal to zero).

39. For the periodic function shown in fig., find the Fourier series coefficients.

281_Figure6.jpg

40. Find the Fourier transform of the waveform shown in fig.

1958_Figure7.jpg

41. The transform voltage V(s) in a network is given be the equation.

V(s) = V(s) = 2(s-1)/((s-3)(s-4))

Plot the poles and zeros and hence obtain the time domain representation if v(t) is causal signal.

Reference no: EM131246202

Questions Cloud

Riskless profits if the futures price was actually : If you can borrow or lend at 10% per year, what should the one-year futures price of silver be if there are no riskless profits to be made? What would you do to make riskless profits if the futures price was actually $22? Show how you got your ans..
Provide a careful visual description of given picture : This is a picture of Cardinal Borghese Sciopione. - Provide a careful visual description of given picture in one and half page.
Identify the major activities included in project start-up : Describe a situation where the elements of the project scope did not specifically exclude an activity that caused a misunderstanding.
Auditor for wartz limited : Chartered Accountants (MQ) was the auditor for Wartz Limited (Wartz) for the financial year ending 30 June 2016. In August 2016, Downtown Limited (Downtown) made a successful takeover offer of Wartz Limited based on the unqualified 2016 audit repo..
Discuss symmetrical conditions in fourier series : Discuss symmetrical conditions in Fourier series - Derive conversion formulae among different types of Fourier Series and state and prove any six properties of Fourier transform and State and prove any four properties of Laplace transform.
What are four of the major activities that occur : What is one type of start-up activity that is affected by the difference in a project's complexity? Describe the difference in that activity between low-, medium-, and high-complexity projects.
Determining the country analysis matrix : Compare the US and one other country. Collect the economic data outlined in the Country Analysis Matrix that is attached. Conduct research through a minimum of three readings from The Economist. Use citations for the three articles from The Econom..
Describe profile of the intended consumer of your product : Describe the profile (demographics, physical, psychological) of the intended consumer of your product/service. Support the importance of your profile to your business/service. As this is a marketing/sales course, your project should be visually appe..
Area of elasticity analysis to improve the odds : What two or three things should most every small business owner do especially in the area of elasticity analysis to improve the odds of their own success? For example, should they insist that their accounting or CPA firms calculate these elasticit..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Lithium ion battery technology

The paper includes Lithium ion battery technology with its advantages and disadvantages. The paper discusses about the Lithium air battery in which detailed reactions of Lithium with air including nonaqueous as well as aqueous are given.

  Power transformers and tariffs

Construction of different types of power transformer, significant energy savings

  Paper on orthogonal frequency-division multiplexing

This document is shown a paper on Orthogonal frequency-division multiplexing with advantages, disadvantages and uses.

  Function of the hmi in a scada system

This assignment contains electronics engineering questions like State the commonly found components of a SCADA (Supervisory control and data acquisition) system. and decribe the function of the HMI in a SCADA system.

  Resultant waveform of the odd harmonic series

Prepare an Excel graph showing the individual components and summated resultant waveform of the odd harmonic series resulting in an approximate square wave.

  Explain scada system

Explain the function of the HMI in a SCADA system.

  Design a 2-digit 24 second shot-clock

Design a 2-digit 24 second "shot-clock" countdown timer with pushbutton controller.

  Model a discrete-time system

To understand di erent signal models To be able to model a discrete-time system and design simple signal processing algorithms.

  Draw a relay construction diagram

Draw a relay construction diagram and briefly explain the operation of a relay.

  Frequency division multiplexing

Write a short technical report on Frequency Division Multiplexing

  Impact of electron energy

Briefly discuss the impact of electron energy, electron current and target on the Bremsstrahlung generated.

  Traffic light controller

The schematic of the traffic light controller

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd