Reference no: EM131384509
The assignment is required to brief the reading materials.
This is not an essay assignment, however, there is a lot of reading for this assignment.
The reading material includes 7 cases.
They are: McCullach v. Maryland, 17 U.S. (4 Wheat.) 316 (1819).
NLRB v. Jones & Laughlin Steel Corp., 301 U.S. 1 (1937).
Wickard v. Fillburn, 317 U.S. 111 (1942).
United States v. Lopez, 514 U.S. 549 (1995).
United States v. Morison, 529 U.S. 598 (2000).
New York v. United States, 505 U.S. 144 (1992).
Printz v. United States, 521 U.S. 898 (1997).
Please be sure to brief each case.
There are six steps for briefing. Please follow the template.
1. Facts: the most relevant legal facts, often called the key facts, are those facts that pose a question about their legal significance because they seem to establish the elements of an applicable rule of law.
2. Procedural history: the procedural history of a case identifies which party prevailed at the trial level and which party is appealing now in which appellate court.
3. Issue: the issue in controversy is the question presented by the key facts in light apparently applicable rule of law. In order to decide the case, the court must answer the legal question presented by the issue.
4. Holding: a holding is the court's direct response to the issue in controversy. It is that law applied to the key facts of the case that is necessary to decide the particular controversy.
5. Judgment: the judgment is the result or disposition of the case and is usually found at the appellate court's opinion, e.g., "judgment for the plaintiff affirmed" or "judgment for the defense reversed."
6. Reasoning: the reasoning is the court's explanation and justification for its holding.
There is no need to write very detail like an essay for each briefing, just keep it short. However, please complete the briefing as one assignment. Do not separate. If possible, you can also complete in few pages. (one or two pages is ok).
Please write in times new roma single spaced font 12.
https://www.dropbox.com/s/83n6t6c2fq63f9c/legislative-cases_combined.rar?dl=0
|
What is the size of the uncalibrated error
: Using the setup and results of Problem 5.14, what is the calibrated level when a 2.13 V level is measured at the filter-buffer output? What is the size of the uncalibrated error?
|
|
What assumptions are necessary to perform given test
: Can you conclude that the variances of the breaking strengths of natural and synthetic fibers are different? Use a level of significance α of 0.05. What assumptions are necessary to perform this test?
|
|
Compute the range and variance
: Find the mean, median, and mode of the processing times. Interpret the differences between them.- Compute the range, variance, and standard deviation of the processing times and interpret them.
|
|
What is the gain and offset of this filter-buffer stage
: Several DC measurements are made on a signal path that contains a filter and a buffer amplifier. At input levels of 1 and 3 V, the output was found to be 1.02 and 3.33 V, respectively. Assuming linear behavior, what is the gain and offset of this ..
|
|
Discuss about the post given below
: Facts: the most relevant legal facts, often called the key facts, are those facts that pose a question about their legal significance because they seem to establish the elements of an applicable rule of law.Procedural history: the procedural histo..
|
|
Find a confidence interval for proportion that uses airline
: Find a point estimate of the proportion of the market that uses this particular airline.- Find a 95% confidence interval for the proportion that uses this airline.
|
|
Estimate the output noise voltage spectral density
: The variation in the output signal of a DUT is 1 mV RMS. Assume that the DUT's output follows a first-order frequency response and has a 3-dB bandwidth of 100 Hz. Estimate the output noise voltage spectral density
|
|
Find confidence interval for the difference in proportion
: Find a 90% confidence interval for the difference in the proportion of people who prefer the stipulated product before and after the advertising campaign.
|
|
By what factor does the settling time increase
: By what factor should the bandwidth of an RC low-pass filter be decreased in order to reduce the variation in a DC measurement from 250 μV RMS to 100 μV RMS. By what factor does the settling time increase.
|