Directly proportional to the pressure gradient

Assignment Help Mechanical Engineering
Reference no: EM131206087

Pressure, Resistance, Flow and Velocity

- Flow rate (Q) is directly proportional to the pressure gradient (?P) and inversely proportional to the resistance: Q = ?P/R

- Resistance is inversely proportional to the 4thpower of the radius (r) of a tube: R = 1/r4

- ?P is directly proportional to resistance: ?P = Flow x R

- velocity = Flow rate (Q) ÷ cross-sectional area (A): v = Q/A

1. Refer to Figure 1 at the end of this document and answer the questions that follow.

1.1 The upper part of the diagram shows a pipe of constant diameter, presumably containing a fluid (liquid). Values of pressure at selected points are indicated. Will there be flow in this pipe? How do you know?

Yes there will be a flow in the pipe.

This is because fluids only flow if there is a positive pressure gradient.

1.2 If the internal diameter of this pipe is 3.6 cm, what will will be its cross- sectional area (A)? (round your answer to the nearest whole number)

Area = πr2

Radius (r) = Diameter /2
Radius (r) = 3.6 /2
Radius (r) = 3.6 /2
Radius (r) = 1.8

Area = πr2
Area =3.14 X (1.8)2
Area =3.14 X (1.8)2
Area =10.17 cm2

1.3 If flow did occur in this pipe, and the flow rate (Q) was 1 mL/min, what will be the velocity (v) of flow?

Velocity (v) = Flow Rate (Q) / Cross-sectional Area (A)

Velocity (v) = 1 / 10.17 mL/min/cm2

Velocity (v) = Flow Rate (Q) / Cross-sectional Area (A)

1.4 If the diameter of this pipe were to change to 0.36 cm, but ?P stayed the same, what would be the new flow rate? Give a brief written explanation (hint: what has happened to the resistance, R?).

2. Figure 2 at the end of this document shows a large vessel with a constriction in the middle: notice that the cross-sectional areas are the same before and after the constriction. Assume a constant flow rate (Q) of 5 L/min and answer the questions that follow. Table cells for which calculated values are required are identified by letters, (a) - (i).

2.1 Calculate the fluid velocities in the 3 parts of the vessel, (a), (b), and (c) [corresponding to cross-sectional areas of 4, 1, and 4 cm2, respectively].

2.2 Explain briefly in words the findings from 2.1.

2.3 Clearly, a flowing fluid will have a kinetic energy: an energy of motion. Calculate the kinetic energy of the fluid at different points-(d), (e), and (f)-using the formula shown in the Figure. (The ρ term, which represents the density of the fluid, can be ignored, as we are considering an homogeneous fluid in this vessel-i.e. the density is constant everywhere. Thus we will calculate a relative measure of kinetic energy, and no units are required.)

Assessed Study Guide

2.4 Comparing the kinetic energies calculated in 2.3, by what factor (multiple) does the kinetic energy at (b) differ from that seen at (a) and (c)?

2.5 A flowing fluid will have a total energy, E, which is the sum of its kinetic energy and its potential energy. The pressure, P, at a given point is a form of potential energy. On this basis, calculate the pressure, P, at each point, (g), (h), and (i). [This will be a relative measure of kinetic energy, so no units are required.]

2.6 You have learned a basic rule: fluids flow down a pressure gradient, from high pressure to low pressure. You will have found in 2.5 that P falls from (g) to (h), so we expect flow from (g) to (h). But what about flow from (h) to (i)? Between these two points, P increases! But, I assure you, there IS flow from (h) to (i). Perhaps our rule concerning flow is incomplete. Taking account of the information compiled, propose a better general rule about fluid flow.

3. Look up the term vascular flutter (NOT atrial flutter). From the information you find and from analogy with the situation arising in Question 2, briefly explain the root cause of vascular flutter.

4. Consider the following statement: In the mammalian circulatory system, the reason velocity of blood flow is lowest at the capillaries is because the very narrow capillaries offer great resistance to blood flow. Is this TRUE or FALSE? Defend your diagnosis. You should include some quantitative evidence in your account.

5. Name at least 3 distinct principles that apply equally regarding air flow in the respiratory system and blood flow in the cardiovascular system. Air and blood are both considered fluids. In what major way do the properties of these fluids differ?

Assessed Study Guide A (Autumn Term, 2015) 3

127_Fig.jpg

Figure 1: A pipe of constant diameter. The values of "P" indicated at intervals represent the pressure at that point along the pipe. For Question 1.

555_Fig1.jpg

Figure 2: The Bernoulli effect exemplified. Letters (a), (b), etc. in the table locate values to be calculated. For Question 2.

Cross-sectional area (A)

4 cm2

1 cm2

4 cm2

Velocity (v)

(a)

(b)

(c)

Kinetic energy 1⁄2 ρv2

(d)

(e)

(f)

Pressure P

(g)

(h)

(i)

Total Energy (E)

3.9 x 107

3.5 x 107

3.1 x 107

Reference no: EM131206087

Questions Cloud

Equivalent annual cost of one machine : What is the equivalent annual cost of one machine if the required rate of return is 12 percent? When solving problem please show all the work so I can gain understanding there are some steps that you need to follow that will assist me:
What do you think about cloning : What do you think about cloning? Is there a universal thought it may violate? Or can it be considered as good for a majority? What are your thoughts, and what are the different questions that can be raised behind them?
Sketch the waveforms of vc and ic : Write the mathematical expressions for the voltage vC and the current iC when the switch is closed. - Sketch the waveforms of vC and iC.
Foundation to develop new projected budget : Create a new 2010 Operating Budget based on the labor decision you select from the Nursing Statistics memo. Use your Week Five Health Care Budget assignment as the foundation to develop your new projected budget.
Directly proportional to the pressure gradient : SCBS037S5.Module Organiser - what will will be its cross- sectional area and this is because fluids only flow if there is a positive pressure gradient.
Define the concepts of bidirectional and epigenesis : Define the concepts of bidirectional and epigenesis and how they are related to the nature-nurture issue in child development. (See Chapter 2 in the textbook.)
Write the mathematical expressions for the voltage vc : Write the mathematical expressions for the voltage vC and the current iC when the switch is closed. - Sketch the waveforms of vC and iC.
Stated annual rate of return : Every month, your employer deposits $1200 into your 401-K account, with the first payment made 1 month from now. The stated annual rate of return on 401-K account is 12%.
Find the waveform for the average current : Find the waveform for the average current if the voltage across a 0.06-µF capacitor is as shown in given figure.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Package design

Package Design Brief: Assume you are the packaging engineer for a large consumer products company. In this company, the Packaging Design Briefs are initiated by the marketing group and forwarded to the Package Engineering group.

  Mechanical engineering questions

Define dynamic viscosity, Determine the centroid, Pressure due to the height of liquid, Advantage of changing the liquid, Calculate the total moment about the hinge of the seal gate.

  Automatic control

DOF system and Find the differential equation describing the system

  Write a paper on boyle''s law

Write a paper on Boyle's law and describe Compression and Combustion stroke . Also explain Charles's law and illustrate SI engine and CI engine.

  Verify the law for parallelogram of forces

To Verify the law for parallelogram of forces, law for triangle of forces and law of polygon of forces. These laws are very useful to calculate unknown forces in very short time.

  Discharge pressure of the compressor

What is the discharge revised discharge pressure of the compressor.

  The Case for Global Accounting Standards

The role of IFRS in both developing and developed capital markets.

  Wind turbine

Wind turbines are becoming more and more common as a method of energy production, wind turbines by their very nature are dynamic and are subject to and create their own internal and external kinematics and kinetics.

  Advanced design methodologies

8 x product engineering and design review (week 2 – 12), ~3 pages per item which must contain a brief description of the product then delve into concepts such as materials selection, manufacturing methods, life cycle analysis, recyclability and overa..

  Design of absorption column and the cooler

Design of absorption column and the cooler. Process design of other units should be completed along with pipe sizes.

  Determine the maximum total bending moment

Determine maximum total bending moment (static plus dynamic) of the beam under steady-state conditions.

  Force of the water on the gate

Determine the magnitude of the horizontal and vertical components of the force of the water on the gate.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd