Diodes & transistors

Assignment Help Other Engineering
Reference no: EM13761948

Diodes & Transistors

Question 1

Copper is a good conductor.

True

False

Question 2

Doping is a process of adding impurity atoms to an intrinsic crystal to alter its electrical conductivity.

True

False

Question 3

You can quickly check the condition of a diode with an ohmmeter on a high resistance range.

True

False

Question 4

The letter Q is an abbreviation for quiescent, which represents the AC signal is operating between cut-off and saturation points of the

transistor.

True

False

Question 5

The half-wave rectifier has a diode in parallel with a load resistor.

True

False

Question 6

In an NPN transistor, the emitter and collector are both n-type materials.

True

False

Question 7

The dc beta is also known as the current gain because a small base current controls a much larger collector current.

True

False

Question 8

The load line is a visual summary of all the possible transistor operating points.

True

False

Question 9

With the switch in the position as shown in Figure 1 below, the LED is on.

True

False

Question 10

A transistor can be tested using an ohmmeter to check back and front resistances of emitter-base, collector-base, and collector-emitter.

True

False

Question 11

Hard saturation refers to any design that makes the saturation current gain approximately:
1
10
100
1000

Question 12

While testing a transistor with an ohmmeter, a high reverse/forward resistance ratio for the emitter-base and base-collector junctions indicates

this transistor is good.

this transistor is open and should be replaced.

this transistor is shorted and should be replaced.

this transistor is a small-signal amplifier.

Question 13

A major advantage of an optocoupler is the:

electrical isolation between input and output circuits.

electrical connection between input and output circuits.

higher gain.

low cost of manufacturing the device.

Question 14

With normal circuit operation, Vout in Figure 2 is ________.
figure 2
Figure 2

Approximately 0V

115 Vac

20 V

10 V DC

Question 15

If the 115 V ac is removed from the circuit shown in Figure 2, what would be measured at Vout?
figure 2
Figure 2

approximately 0 V

115 V

20 V

10 V

Question 16

What type transistor connection is shown in Figure 3 below?

common emitter

common collector

common base

emitter follower

Question 17

What is the device that increases a transistor's power rating by reducing the internal heat faster?

heater wire

chassis

grommet

heat sink

Question 18

Another name for diode offset voltage is:

barrier potential

ripple voltage

surge voltage

filtered voltage

Question 19

The second approximation of a silicon diode is basically the:

the diode appears as a switch in series with a barrier potential of 0.7 V

the diode appears as a switch in parallel with a barrier potential of 0.7 V

the diode appears as a barrier potential of 0.4 V

the diode appears as a short circuit

Question 20

What is the most popular and useful semiconductor material?

silver

Copper

Aluminum

Silicon

Question 21

What is the Peak secondary voltage?
What is the peak-to-peak voltage at the filter point considering non-ideal diode?

Question 22

For the CE circuit shown in Figure 5 below, draw the dc load line and mark the dc working point on it. Assume Beta=100 and neglect

VBE.

Reference no: EM13761948

Questions Cloud

Design analog circuit using transistor : Construct the circuit shown in Figure 1 below with the parameters shown in the circuit.
Define what professional organizations you might join : Assignment : I need someone to Write a no more than 2-page paper discussing what professional organizations you might join, and websites you might visit, that would provide insight into a career in network security that includes responsibility for..
Comparisons and contrasts of a command and mixed economies : What are five comparisons and contrasts of a command and mixed economies?What are five comparisons and contrasts of a market and mixed economies?
Recreate simulation in performing monte carlo simulation : Assignmnet 1: Assignment Preparation: Activities include completing the SkillSoft courses, watching the Lynda.com videos, independent student reading, and research. Recreate the simulation presented in the "Performing Monte Carlo Simulation" video
Diodes & transistors : Copper is a good conductor.Doping is a process of adding impurity atoms to an intrinsic crystal to alter its electrical conductivity.
Several months of data showed the cpi increasing : Suppose that several months of data showed the CPI increasing at a 4.5% annual rate due largely to increases in the price of energy and food related commodities following several years when the CPI only increased by 1% per year. Suppose thisincrease ..
Company revenue for year : If Barsuk's ending stockholders' equity was $581,000, what was the company's revenue for the year?
Backup utility programs : Of the five general categories of data analysis tools, which of the following is most commonly used by local agencies because it allows the investigator to quickly identify questionable graphics files?
Write a theater art essays on play fences and everyman : Write a Theater Art Essays on play fences and Everyman. Consider the following: What does the playwright intended to do? What does the film maker intended to do?

Reviews

Write a Review

Other Engineering Questions & Answers

  Characterization technology for nanomaterials

Calculate the reciprocal lattice of the body-centred cubic and Show that the reciprocal of the face-centred cubic (fcc) structure is itself a bcc structure.

  Calculate the gasoline savings

How much gasoline do vehicles with the following fuel efficiencies consume in one year? Calculate the gasoline savings, in gallons per year, created by the following two options. Show all your work, and draw boxes around your answers.

  Design and modelling of adsorption chromatography

Design and modelling of adsorption chromatography based on isotherm data

  Application of mechatronics engineering

Write an essay on Application of Mechatronics Engineering

  Growth chracteristics of the organism

To examine the relationship between fermenter design and operating conditions, oxygen transfer capability and microbial growth.

  Block diagram, system performance and responses

Questions based on Block Diagram, System Performance and Responses.

  Explain the difference in a technical performance measure

good understanding of Mil-Std-499 and Mil-Std-499A

  Electrode impedances

How did this procedure affect the signal observed from the electrode and the electrode impedances?

  Write a report on environmental companies

Write a report on environmental companies

  Scanning electron microscopy

Prepare a schematic diagram below of the major parts of the SEM

  Design a pumping and piping system

creating the pumping and piping system to supply cool water to the condenser

  A repulsive potential energy should be a positive one

Using the data provided on the webvista site in the file marked vdw.txt, try to develop a mathematical equation for the vdW potential we discussed in class, U(x), that best fits the data

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd