Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1 .With the help of the logic diagram, describe the operation of a clocked R-S flip-flop with active LOW R and S inputs. Draw the truth table of this flip-flop if it were negatively edge triggered.
2. Differentiate between a D flip-flop and a D latch.
The system uses a 7-cell reuse pattern. If the offered traffic per user is 0.03 Erlangs and the average number of calls per hour per user is 1.5, for an Erlang-C system with a probability of delaying a call being 5%, calculate the traffic load per..
MOS (p and n) npn and pnp transistors with parameters given in the text or select your own by using industrial data sheets, available on the internet. Also resistors, capacitors, and power supplies (10 V, 5 V, and 3.3 V) are available.
The flat circular disk rotates about a vertical axis through O with a slowly increasing angular velocity ?. Prior to rotation, each of the 0.44-kg sliding blocks has the position x = 22 mm with no force in its attached spring.
Which of the following summarizes the important features of emitter-coupled logic (ECL)? What is the word ‘interfacing' as applied to digital electronics means? What are the different TTL families?
Your circuit should consist of only the following elements: one 1 ohm resistor, one 2 ohm resistor, three 10 ohm resistors, three ideal constant voltage sources, and three ideal ammeters,
Develop a FSM for a priority arbiter, in which subsystem 0 has highest priority and subsystem 3 has least priority. A pending request from a higher-priority subsystem takes precedence over a pending request from a lower-priority system.
Construct a partial-fraction expansion of F(s) and find f (t).- Construct a pole-zero diagram of F(s) and identify the dominant poles.
What do you understand by the terms "hogging" and "sagging" in relation to longitudinal strength? Explain how you would go about finding the longitudinal bending moment amidships of a ship:
A. There are three part conveyor lines (1-2-3) feeding a main conveyor. Each of the three conveyor lines has its own counter. Construct a PLC program to obtain the total count of parts on the main conveyor. B. Add a timer to the program that will ..
The surface concentration is fixed at N0=1.8e20/cm^2 when diffusing boron into a uniformly doped n-type substrate. The atomic diffusion constant for boron in Si at the temperature of 950 C is 3.0e-15 cm^2/s.
A single-phase power system is shown in Figure P3-1. The power source feeds a 100-kVA 14/2.4-kV transformer through a feeder impedance of 38.2 + j140 W. The transformer's equivalent series impedance referred to its low-voltage side is 0.12 + j0.5 ..
1. materials are deep-seated in human culture. do you agree with this statement? why or why not? give examples of
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd