Did the biker go uphill or downhill

Assignment Help Mechanical Engineering
Reference no: EM13704002

1. Many bike computers tell the ride what altitude they are at and how the altitude is changing using a basic barometer and pressure differences. A biker rides on a hill and the computer reads barometric pressures of 475 mm Hg at the start and 530 mm Hg at the end. Assume the air density is 0.9 kg/m3 at the altitude the bike is at. (a) Did the biker go uphill or downhill? Why? (b) How high was the hill? (b) Did the rider go up a hill or down a hill? (c) What altitude did the biker start at?

2. The absolute pressure in a tank is 115 kPa. If the tank is sitting at sea level and manometer were used to measure the pressure what would the height of the liquid column in the manometer be if the fluid was (a) mercury (SG = 13.6) or (b) Water (SG = 1.0)?

Reference no: EM13704002

Questions Cloud

What is the temperature change of the water : Liquid water at 26.67°C flows in a straight horizontal pipe in which there is no exchange of either heat or work with the surroundings. Its velocity is 40 ft/seg in a pipe with an internal diameter of 2.54 cm until it flows into a section where the p..
Carbon annealed steel rod has a rectangular cross section : The company has been asked to assess the effects of a variety of engineering conditions on a selection of components, perform calculations for the components that follow. A medium carbon annealed steel rod has a rectangular cross section and must cop..
What will the total pressure become : A 9.75-L container holds a mixture of two gases at 45 °C. The partial pressures of gas A and gas B, respectively, are 0.186 atm and 0.820 atm. If 0.190 mol of a third gas is added with no change in volume or temperature, what will the total pr..
Hydrogen atoms replaced respectively with chlorine atoms : Methyl chloride, methylene chloride, chloroform, and carbon tetrachloride are all part of what group that has had one, two, three, or four hydrogen atoms replaced respectively with chlorine atoms?
Did the biker go uphill or downhill : Many bike computers tell the ride what altitude they are at and how the altitude is changing using a basic barometer and pressure differences. A biker rides on a hill and the computer reads barometric pressures of 475 mm Hg at the start and 530 mm Hg..
What is the balanced equation : If 2.0 grams of calcium chloride react with 3.5 grams of sodium hydroxide in a double replacement what is the balanced equation
Describe the strengths and weaknesses of the evaluation : Describe the occasion in which you were being evaluated. Describe the strengths and weaknesses of the evaluation process using concepts and/or theories from the week's readings.
What will be the deflection of the cables : A 4oo pound chandelier is to be hung from two 10 ft long solid steel cables in tension. Choose a suitable diameter for the cable such that the stress will not exceed 5000 psi. What will be the deflection of the cables? State all assumptions.
A race car starting from rest travels along a straight road : A race car starting from rest travels along a straight road and for 10 s has the acceleration shown. Construct the v - t graph that describes the motion and find the distance traveled in 10s.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Package design

Package Design Brief: Assume you are the packaging engineer for a large consumer products company. In this company, the Packaging Design Briefs are initiated by the marketing group and forwarded to the Package Engineering group.

  Mechanical engineering questions

Define dynamic viscosity, Determine the centroid, Pressure due to the height of liquid, Advantage of changing the liquid, Calculate the total moment about the hinge of the seal gate.

  Automatic control

DOF system and Find the differential equation describing the system

  Write a paper on boyle''s law

Write a paper on Boyle's law and describe Compression and Combustion stroke . Also explain Charles's law and illustrate SI engine and CI engine.

  Verify the law for parallelogram of forces

To Verify the law for parallelogram of forces, law for triangle of forces and law of polygon of forces. These laws are very useful to calculate unknown forces in very short time.

  Discharge pressure of the compressor

What is the discharge revised discharge pressure of the compressor.

  The Case for Global Accounting Standards

The role of IFRS in both developing and developed capital markets.

  Wind turbine

Wind turbines are becoming more and more common as a method of energy production, wind turbines by their very nature are dynamic and are subject to and create their own internal and external kinematics and kinetics.

  Advanced design methodologies

8 x product engineering and design review (week 2 – 12), ~3 pages per item which must contain a brief description of the product then delve into concepts such as materials selection, manufacturing methods, life cycle analysis, recyclability and overa..

  Design of absorption column and the cooler

Design of absorption column and the cooler. Process design of other units should be completed along with pipe sizes.

  Determine the maximum total bending moment

Determine maximum total bending moment (static plus dynamic) of the beam under steady-state conditions.

  Force of the water on the gate

Determine the magnitude of the horizontal and vertical components of the force of the water on the gate.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd