Develop the skills to write a report

Assignment Help Case Study

Reference no: EM13710401

Write a report not exceeding 1000 words.

Develop the skills to write a report.

Activity:

One of the requirements of this course is to write a report. The mark allocated for the paper constitutes 10 % of the total mark of the course. You can choose any scientific or informative report to write about. You

should include the following in the report:

1. Plastic spiral cover

2. Title Page

3. Table of Contents

4. List of Illustrations/ Graphics

5. Introduction

6. At least three chapters that cover the discussion part

7. Conclusion /Summary

8. List of References

Pls write it in simple and clear english.

Verified Expert

Reference no: EM13710401

Questions Cloud

Air flows steadily through one-inlet-one-exit control volume : Air flows steadily through a one-inlet, one-exit control volume. At the inlet, which has a flow area of 28 cm2, the air is at 600 kPa, 500 K, and has velocity of 30 m/s. At the exit, the pressure is 300 kPa, the temperature is 456.5 K, and the veloci..

The fugacities of ethane and n-butane in equimolar mixture : Compute the fugacities of ethane and n-butane in an equimolar mixture at 373.15K at 1, 10, and 15 bar total pressure assuming that the Lewis-Randall rule is correct.

How much water is needed-ignores change in kinetic energy : An ADIABATIC steam turbine works between inlet pressure of 100 bar and outlet pressure of 25 bar. The inlet temperature is 600 degrees Celsius. Outlet steam has a quality of 90 percent. You want to know if this facility is fit to generate your need o..

Heat transfer and work transfer for the two-step process : Ten pounds-mass of R-22 is at an initial volume of 4.059 ft3 and pressure of 200 psia. It is compressed isobaric ally until its volume is two-thirds of its initial volume. The piston is then held in place as the refrigerant cools until its temperatur..

Develop the skills to write a report : Develop the skills to write a report - One of the requirements of this course is to write a report.

In a specific type of heat exchanger : In a specific type of heat exchanger, a very hot jet of air is cooled from 145 degrees centigrade to 100 degrees centigrade by a cold stream of water. The water temperature must not rise By more than 12 degrees centigrade. Find 1.

What is the polytropic exponent of this process : Air, initially at 220 kPa and 450 K undergoes a polytropic state change to 374 kPa and 495 K. What is the polytropic exponent of this process? Saturated water vapor is contained in a rigid container. Heat is then added until the pressure and temperat..

What is the outlet to inlet area ratio of this diffuser : Design a ceiling diffuser. Air flows in the duct behind the diffuser and enters the diffuser at a pressure of 12.8psia, and a velocity of 200in/sec. The outlet of the diffuser is in the room, with atmospheric pressure of 14.5 psi. For the comfort of ..

Wedges-learning goal : The crate shown is held against wedge B by a spring. The spring is 94.5% of its original uncompressed length l=2.75m, and the spring constant is given as k=1650N/m. The coefficient of static friction at all contacting surfaces is ?s=0.130. The mass o..

User Account

All Pages