Develop the receiving end performance chart

Assignment Help Electrical Engineering
Reference no: EM132315863

Question 1. (a) A short 3-phase 11 kV line delivers a load of 4.1 MW, 2.6 MVAr lag. If the series impedance of the line is (72 + j12.1)Ω/ph, calculate the sending end voltage and load angle.

(b) Develop the receiving end performance chart for the above line and load to a 3-phase power scale. (Use a scale of 10 nun = 1000 V and 30 mm = 4.1 MW)

Question 2. Using the chart you produced in Question 3, determine: (a) the real and reactive power when

(i) the transmission angle remains unaltered and the sending end voltage is increased by 28%

(ii) the original sending-end voltage is reduced by 15% and the transmission angle increased by 9°. (Use the same scale as that for Question 3 (b))

(b) the real power limit for the sending voltage in (ii) above (i.e. when reduced by 15%).

Reference no: EM132315863

Questions Cloud

Do you agree with idea that bigger is not necessarily better : Ewing, Boudette and Dooley (2019) presented interesting and compelling pros and cons for the proposed Fiat-Renault merger. Check out the article listed below.
How to make adjusting entry for unearned revenue : For Dobbs Co., journalize and post the entry on July 1 and the adjusting entry on December 31. how to make adjusting entry for unearned revenue?
Relationship between the mental illness and physical illness : Post an explanation of the relationship between the mental illness and physical illness. explain how this relationship might impact patient's course of life.
How has the internet made plagiarism issues worse : How has the Internet made plagiarism issues worse? Why? What should be the appropriate punishment for a student who is caught plagiarizing?
Develop the receiving end performance chart : Develop the receiving end performance chart for the above line and load to a 3-phase power scale. (Use a scale of 10 nun = 1000 V and 30 mm = 4.1 MW)
How would you feel if a co-worker took the credit : How would you feel if a co-worker took the credit for your ideas? How would you feel if a co-worker took the credit for your ideas? How do you think it might.
Post the entry on july 1 and the adjusting entry on december : Using the data that I put below, journalize and post the entry on July 1 and the adjusting entry on December 31 for Kalter Insurance Co. Kalter uses.
Solve the proportion : Solve the proportion 3/5 = x/15. Solve 60s + 4 = 56s + 50. Find 35% of 130. Solve 5|x-3| = 25
Discuss the length of time the slave trade operated there : Identify your selected country's date of independence from the colonial ruling country, and discuss the length of time the slave trade operated there.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  For what fraction of acycle does each diode conduct

A half-wave rectifier circuit with a 1-Kwload operates from a 12-v(rms) 60-Hz household a 5-to 1 transformer having a center-tappedsecondary winding. It use two silicon diodes that can be modeled tohave a 0.7-v drop for all currents.

  Will the motor work or not

A three-phase induction motor is required to operate from a single-phase source. One possible connection is shown in Figure P18.28. Will the motor work? Explain why or why not.

  Produce a set of calibration figures for the control loop

Produce a set of calibration figures for the control loop TICA1495. TI1495 range = 100 to 420°C TICA1495 SP = PV = 300°C TCV1495 = 30%.

  What amount voltage is required to obtain the field

Electrons in silicon carbide have a mobility of 1000 cm^2/V-sec. At what value of the electric field do the electrons reach a velocity of 3 X 10^7 cm/s Assume that the movility is constant and independent of the elctric field.

  Draw a cmos circuit for an s-r flip-flop

Explain the basic operation of a CMOS transmission gate and compare it to a tri-state buffer. There is one important difference, make sure to explicitly discuss that difference.

  How the volume of the tank varies as a function of time

Find how the volume of the tank varies as a function of time, if the inlet and outlet flow-rates vary. List the state variables.

  How does a digital controller function

List the general steps that a digital controller program follows.

  Derive the form of the filter that maximizes the snr

Derive the form of the filter that maximizes the SNR at the output of the filter at time t =tO To make this problem simpler, you do not need to insist that the filter is causal.

  What are the impedance and the component value of the load

A balanced, three-phase, Y-connected source has a line voltage of 440 Vrms. The source frequency is 60 Hz. The balanced, three-phase loads have the following characteristics: Zy1: P1 = 15 kW and Q1 = +18 kVAR Z?2: |S2|=21 kVA and PF2 = 0.500 laggin..

  Create a function that plots the function sinc(x) = sin (px)

Create a function that accepts as input argument a number in radians and returns its value in degrees. b. Compute (through your function) how many degrees is p=4 radians.

  Calculate the speeders speed with respect to the ground

A speeder is pulling directly away and increasing his distance from a police car that is moving at 25.1 m/s with respect to the ground. The radar gun in the police car emits an electromagnetic wave with a frequency of 7.16E+9 Hz.

  What are the units of measurement for each statistic

Calculate the sample mean, sample variance, and sample standard deviation. What are the units of measurement for each statistic?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd