Develop a preliminary design, including flow rates

Assignment Help Civil Engineering

Reference no: EM13535607

Develop a preliminary design, including flow rates, pipe sizes, and pipe slopes for a trunk sewer to be laid in the development shown in the accompanying figure from 6th to 1st Streets along Peavy Avenue.

Assume the following data apply

(a) Saturation population and flow data

Zoning Type of development Saturation population density, person/ha Wastewater flow,

L/capita. d

Residential Single-family dwellings 30 380

Residential Duplexes 50 310

Residential Low-rise apartment 100 260

Residential High-rise apartment 160 220

Peaking factor for residential area

(b) Wastewater flow and peaking data for commercial and industrial areas and institutional facilities.

Area/facility Flow (basis) Value Peaking factor

Commercial m3/ha.d 32 1.5

Industrial m3/ha.d 60 2.2

School L/student.d 80 3.5

Park L/person.d 30 4.0

(d) Assume parks usage is 500 persons/d

(e) Assume flow from upstream area is equal to 0.005 m3/s.

(f) For infiltration allowance

(i) For residential areas, obtain the peak infiltration values from the following figure.

(ii) For commercial, industrial, and institutional areas, also obtain the peak infiltration values from the same figure. However, use only 50 percent of the actual area to compute the infiltration allowance.

(g) Assume inflow can be neglected.

(h) For the hydraulic design equation use the Manning equation with an n value of 0.013.

(i) The local sewer code specifies 200 mm as the smallest pipe permissible.

(j) Use 0.75 m/s as the minimum velocity during the peak flow conditions.

(k) The minimum depth of cover over the top of the sewer is 2.0 m.

Reference no: EM13535607

Questions Cloud

What is normally consolidated clay : Compute the nominal shear strength of an M10 x 7.5 of A 572 grade 65 steel

Compute the probable settlement of the building : The construction of a multi storied building started in January 1989 & was completed in June 1990. The total consolidation settlement of the building was estimated to be 8 cm.

Determine the quantify the losses in this system : At Point A, in a pipeline carrying water (γ=62.4 lb/ft^3) the diameter is 4.0 ft, the pressure is 10 psi, and the velocity 4 ft/s. At point B, 6ft higher than point A, the diameter is 2 ft and the pressure is 2ps

What is the average crack spacing for that reinforcement : Compute the effective composite modulus of subgrade reaction (please consider the subbase, the presence of a relatively shallow rock foundation, and the potential loss of support)

Develop a preliminary design, including flow rates : Develop a preliminary design, including flow rates, pipe sizes, and pipe slopes for a trunk sewer to be laid in the development shown in the accompanying figure from 6th to 1st Streets along Peavy Avenue.

Compute the atomic packing factor for cesium chloride : Compute the atomic packing factor for cesium chloride assuming thatthe ions touch along the cube diagonals. Ionic radii ofCs+ and Cl- are 0.170 nm and 0.181 nm,respectively

Show calculations to justify your answer : Are installed together? Show calculations to justify your answer and sketch a specific energydiagram to illustrate the process of changes in flow depth in eachcase.

In what ways do the experts foresee the use : Review the literature and analyze the strengths and weaknesses of both virtualization and cloud computing in providing secure and trusted systems.

Describe the security implications of using these technology : Describe the security implications of using these technologies and how risk will be mitigated from a network hardware and software perspective.

User Account

All Pages