Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Parallel Computing questions:
1. Develop a parallel program to find a given element in an unsorted array (a large number of elements starting from 10K can range to 1 lakh and above, based on the memory) using Linear Search. Compare the execution time with the Sequential Linear Search program. Also compare it with the sequential Binary Search program.
2. Develop a parallel program to find a given element in an unsorted array using Binary Search. Take a large number of elements upto the maximum possible size. Note: Make use of openmp task directive. Also compare the result with the sequential version of Binary Search.
A 200-MW power plant generates electricity with an efficiency of 40%, with 87% of this waste heat removed via cooling water. The average flow in the river to which this cooling water will be discharged is 45 m^3/s, and the plant wishes to discharge i..
A barge is 60ft long, 20ft wide, and 8ft deep. When empty, it weighs 210,000lb, and its center of gravity is 1.5ft above the bottom. Is it stable when floating in water?
Assuming a standard driver reaction time of 2.5 seconds, what is the probability that the vehicle pulling out will get in an accident with oncoming traffic?
The shaft diameter is 100 mm. Calculate the largest principal stresses and maximum shear stress that will occur in the shaft.
find the maximum allowable force P if the maximum allowable bearing stress on 6 pins holding 2plates together is σ all=10 MPa, and the maximum allowable shear stress is τ all =25 MPa
A tangent section of highway has a -1.0% grade and ends at station 0+1450and elevation 25m. It must be connected to another section of highway that has a -1% grade and that begins at station 1+345 and elevation 40m.
An earth fill is constructed across a drainage. Closed contours at the 1000, 1040 and 1080 foot levels define areas of 680,000; 1,200,000; and 1,325,000 square feet respectively.
SEV323 - Steel Structures - Calculate the maximum kN/m design load required to estimate the amount of weld required to safely attach the cover plate to the girder flanges. You are not required to calculate the amount of weld.
Derive expressions for the near-tip mode I and mode II
the turbopump unit in the engine nominally operates at 7000 rpm, and a result of design issue, the actual thrust provided by the engine oscillates harmonically with an amplitude of 10 KN at the same rotational frequency as the turbopump unit.
Determine the influence line ordinates for R1 for the two-span pin-jointed truss shown in Figure S5.4as unit load crosses the bottom chord. All members have the same cross-sectional area, modulus of elasticity, and length.
The propellor is situated at the end of the tunnel wherethe area is 10 m2 (rigth before the tunnelis opened to the atmosphere). So I used the energyequation, but I have two unknows: pressure P of thetest section, and the shaft work hT orhP (I am not ..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd