Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Message signal= sin(2pi fo t)Where fo=20hz and fs=700hza). Develop a function with the name myAMmod to modulate the message signal. Use a carrier frequency fc=200hz. Plot the magnitude spectrum of the message signal and the modulated signal and explain the difference between them. You may not MATLAB syntax; ammod.b). Develop a function with the name myamDmod to demodlate the output of part a). You may not us MATLAB syntax; amdemo.c). Plot the frequency spectrum of the demodulated signal. Compare it with the original message signald). plot the demodulated signal in the time domain. Compare it with the orginal message signal.
calculate the resistor's resistance. If the bandwidth were cut to 25 kHz, determine the expected output meter reading.
Explain why it is unlikely one would encounter a circuit exhibiting a critically damped response in practice. What impact would time and temperature have on a supposedly "critically damped" circuit
1) Modern technology has produced a small 1.5-volt alkaline battery with a nominal stored energy of 150 joules. For how many days will it power a calulator that draws a 2-mA current 2)The current entering the positive terminal of an element is
Write a testbench stimulus for the below 8-bit Shift-Left Register with Positive-Edge Clock, Serial In and Serial Out. Start with all ones after the 8th=bit shifted to the left all zeros.
Two Random variables have a joint probability distribution function defined by F(x,y)=0 X 1y>1 A). Sketch this distribution function. B). Find the joint probability density function and sketch it.
Compare the by hand solution and the PSPICE simulation for a voltage amplifier which has an input resistance of 10kohms and an output resistance of 100ohms, and a gain of 100V/V. The voltage amplifier is capacitively coupled to a voltage source.
a) It is required that the propagation delay be limited to 60 psec. Find the required device widths b) Find the High and Low noise margins, i.e. NMH and NML. c) What is the peak current drawn from VDD during switching of the inverter What is the aver..
Design Problem- the circuit must have the following transfer function: Tv(s)=+- (s+125)(s+500)/(s+250)(s+1000) a)design the circuit using two Omp-amps B) design a circuit using only one omp-amp c) design a circuit using no omp amp *in all designs ..
If a frame is damaged then in this network the receiver sends back a request for retransmission. (For simplicity, assume all these requests arrive back perfectly at the sender). What is the mean number of transmissions required to successfully tra..
A single phase 1750 RPM moter operating at rated power has a power factor of 0.75 lagging. the line voltage is 208 VAC @60 Hz and the line current is 27A. Assuming 83% is a reasonable efficiency for moters of this size
Two balanced Y-connected loads in parallel, one drawing 15 kW at 0.6 power factor lagging and the other drawing 10 kVA at 0.8 power factor leading, are supplied by a balanced, three-phase, 480-volt source.
A collector modulated transmitter has a supply voltage of 48 V and an average collector current of 600 mA. What is the input power to the transmitter How much modulating signal power is needed to produce 100 percent modulation
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd