Determine what would the resistance of the fish be

Assignment Help Electrical Engineering
Reference no: EM13295569

An electric eel deliveres a current of 0.75A to a small pencilthin prey 15 cm long. If the eels bio-battery was charged to 500Vand it was constant for 20 ms before dropping down to 0, what would the resistance of the fish be, the energy delivered to the fish,and the average electric field( magnitude) in the fish's flesh.?

Reference no: EM13295569

Questions Cloud

What must the nominal interest rates be on the second option : What must the nominal interest rates be on the second and third options to make all the investments earn the same yield?
At what speed will you move back toward the station : You took a job as a space station scientist. On a spacewalk you get separated from the station. At what speed will you move back toward the station
Explain delta u for the reversible isothermal expansion : Find delta s, q,w, and delta u for the reversible isothermal expansion of 3.000mol of argon (assumed ideal) from a volume of 100.0L to a volume of 500.0L at 298.15K
What is the difference in values at the end of five years : If you buy from each bank a five year, $1,000 certificate of deposit, with all interest compounded, what is the difference in values at the end of five yeas.
Determine what would the resistance of the fish be : If the eels bio-battery was charged to 500Vand it was constant for 20 ms before dropping down to 0, what would the resistance of the fish be, the energy delivered to the fish, and the average electric field( magnitude) in the fish's flesh.
Evaluate the initial speed of the bullet : A 4-g bullet is fired into a 1.4-kg block that is resting on a table. After impact, What was the initial speed of the bullet?
What is one year interest rate expected one year from now : Suppose we observe the following rates: 1R1=8%, 1R2=10%. If the unbiased expectations theory of the term structure of interest rate holds, what is the one year interest rate expected one year from now.
Explain what is being oxidized and what is being reduced : What is being oxidized and what is being reduced: feso4 + k2cr2o7 + h2so4 = cr2(so4)3 + fe2(so4)3 +h2o + k2so4
Should a firm normally have more confidence : Diaz Camera Company is considering two investments, both of which cost $10,000. The cash flows are as follows: Year1, Project A $6,000, Project B $5,000 - Year 2, Project A $4,000, Project B $3,000 Year 3, Project A, $3,000, Project B $8,000.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Write the analytical expression for the waveforms

What would be the initial value of v c (t) when switch is closed and determine the time constants in both cases (switch is open, switch is closed).

  Find combined real power drawn y the loads in kilowatts

Two Parallel single-phase loads are supplied by a 480 volt RMS, 60 Hz, source. The two loads are: Load 1 : 15.0 kW at .6 lagging p.f. Load 2 : 25.0 kVA at .8 lagging p.f. 1) the combined real power drawn y the loads in Kilowatts

  Determine the capacitance values for each case

Simulate the second-order RLC circuit using simpower Matlab simulink.This circuit has DC source voltage Vs=220V, Inductance L=2mH and Resistance R=160 ohms.Determine the capacitance values for each case

  Calculate the impedence of the load for the given case

A three-phase, 480 V system is connected to a balanced Three-phase load. The line Current (Ia)is 10A and is in phase with the line-to-line voltage Vbc. calculate the impedence of the load for the following case.

  Explain what should the signal definitions be

What should the signal definitions be for the equations, such that the minimal about of hardware (gates) are used assuming we have an abundance of NAND gates Show the signals definitions and resulting circuitry.

  What is the internal resistance of the battery

When the starter motor, which draws 90A, is running the terminal voltage drops to 11V. What is the internal resistance of the battery What percentage of the chemical power is delivered to the starter motor

  Define the winding resistance and leakage reactance

A 415V to 11 kV transformer has a rating of 200 kVA. The winding resistance and leakage reactance when referred to the primary are 0.014 and 0.057 ohms respectively.

  Determine the noise on the output as percent fs

A system is needed to measure flow, which continuously cycles between 20 and 30 gal/min with a period of 30 sec. The required output is a voltage varying from -2.5 to +2.5 V for the cycling flow range. The sensor to be used has a transfer function..

  Explain what is the fundamental frequency of the spectrum

What is the fundamental frequency of the spectrum of the square wave? What is the magnitude of the fundamental frequency component of the spectrum of the square wave?

  What minimum tracking bandwidth must tdrs receiver possess

What minimum tracking bandwidth must the TDRS receiver possess in order to accommodate the Doppler effect (Hint: you need to include both the velocity of the LEO satellite and the velocity of the GEO satellite. To the LEO satellite, the GEO satell..

  Find the minimum sum-of-products form for f

(a) Find the maxterm expression for F. Express your answer both in decimal and algebraic form. (b) Use a Karnaugh map to find the minimum sum-of-products form for F'. (c) Find the minimum product-of-sums for F.

  Determine what is the magnitude of the output voltage

A circuit has an 9 ohm resistor in series with a 0.30 mF capacitor. The input voltage is vIN(t) = 14 cos (400t - 30o) V. The output voltage is measured across the resistor. what is the magnitude of the output voltage

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd