Determine what will be the discharge through the pipe

Assignment Help Civil Engineering
Reference no: EM13319627

A pump having the characteristics given( N=2133.5 rpm, n=35.6 rps, D=37.1 cm) pumps water at 25 degree C from a reservoir at an elevation of 366 m to a reservoir at an elevation of 450 m through a 36 cm steel pipe. If the pipe is 610 m long, what will be the discharge through the pipe?

Reference no: EM13319627

Questions Cloud

British pound sterling. at what rates will morgan guaranty : Suppose Morgan Guaranty, Ltd. is quoting swap rates as follows: 7.75 - 8.10 percent annually against six-month dollar LIBOR for dollars and 11.25 - 11.65 percent annually against six-month dollar
Find the induced emf in the inductor : A 2.3A current is flowing in a 25H inductor. A switch is opened, interrupting the current in 1.0ms. Find the induced emf in the inductor
Find the operating points for two identical pumps connected : The pump curve for a given pump is represented by hp,pump=20 (1-(Q/100)^2) where hp,pump is the head provided by the pump in feet and Q is the discharge in gpm.
If the cost advantage of interest rate swaps would likely be : If the cost advantage of interest rate swaps would likely be arbitraged away in competitive markets, what other explanations exist to explain the rapid development of the interest rate swap market?
Determine what will be the discharge through the pipe : A pump having the characteristics given( N=2133.5 rpm, n=35.6 rps, D=37.1 cm) pumps water at 25 degree C from a reservoir at an elevation of 366 m to a reservoir at an elevation of 450 m through a 36 cm steel pipe.
Discuss what mechanisms may be used to solve this problem : Explain “free cash flows.” Why do managers like to retain free cash flows instead of distributing it to shareholders? Discuss what mechanisms may be used to solve this problem?
Determine the work input required using both s0 and pr data : Air enters a steady flow, adiabatic compressor at 17 °C and is compressed through a pressure ratio of 8.6: 1. Assuming the compressor to be internally reversible
Identify and explain the 5 principles of accounting : Identify and explain the 5 principles of accounting and how they apply to the financial statements specific to your healthcare institution.
Determine natural circular frequency of disk for oscillation : The mass center of the unbalanced disk of weight W is located at G, which is a distance of R/2 from the center for the disk. In the equilibrium postition, the two springs attached to the rim of the disk are undeformed.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine what constricted width would be to force the flow

Given that uniform flow is subcritcal and there is a constriction in a rectangular channel, how do you determine what the constricted width would be to force the flow to be critical. Draw this transition on a specific energy curve.

  How many kilograms each of pearlite

how many kilograms each of pearlite and preutectoid phase form? schematically sketch and label the resulting microstructure

  What is the moment at the free end of the cantilever

Consider a cantilever beam with a trapezoidal load along the length, a concentrated load at its free end, and an applied moment at the mid-span of the beam. What is the moment at the free end of the cantilever

  What is the concentration of nh3of household ammonia

What is the concentration of NH3 (in mg/L) of household ammonia that contains 3.00 percent by wieght of NH3. Assume the density of water = 1000kg/m^3

  Calculate ph of buffer solution prepared by mixing water

Calculate the pH of a buffer solution prepared by mixing 8.5g KH2PO4 with 43.5g K2HPO4 in 1 liter of water (this is actually the composition of the dilution water used in a BOD test. Follow the same procedures you have been using for previous acid/..

  What is the average density of the actual solids contained

a 50cm^3 sample of dry soil from an aquifer weighs 100g. when it is poured into a graduated cylinder, it displaces 35cm^3 of water. What is the porosity of the soil. What is the average density of the actual solids contained in the soil

  Determine number of revolutions it must undergo to acquire

A wheel has an initial clockwise angular velocity of 12 rad/s and a constant angular acceleration of 3 rad/s2. A) Determine the number of revolutions it must undergo to acquire a clockwise angular velocity of 15 rad/s.

  Plot the shape of the water surface from the center

a whirlpool is modeled as the combination of a free and a forced vortex. the maximum velocity in the whirlpool is 10 m/s, and the radius at the juncture of the free and the forced vortex is 10m.

  What thickness of bc will result in same compressive stress

A second load P2 is uniformly distributed around the cap plate at B. The diameters and thicknesses of the upper and lower parts of the post are dAB= 1.25 in, tAB= 0.5 in, dBC= 2.25 in and tBC= .375 in respectively.

  Calculate the pressure inside a 2-mm diameter bubble

Calculate the pressure inside a 2-mm diameter bubble of water at 20°C and compare with the pressure inside a 2-mm diameter droplet of water at 20°C.

  Determine what would the deflection be at the right end

A 2-inch by 2-inch solid steel beam (18 inches long) is fixed to the wall at the left to resist applied moment (20,000 lbs-inch). What would the deflection be at the right end Up or down

  Determine the 50-kg crates velocity when t is given

If the force exerted on cable AB by the motor is F =(100^3/2) N, where t is in seconds, determine the 50-kg crates velocity when t = 5s. The coefficents of static and kinetic friction between the crate and the ground are u(s) =.4

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd