Determine what voltage value will be measured

Assignment Help Electrical Engineering
Reference no: EM13263855

measure a voltage between two points on the human body. We can model the human body as a voltage source in series with a high resistance, let's say 10mV in series with 100kOhms. If we use an instrument with 1MOhm input resistance, what voltage value will we measure?

Reference no: EM13263855

Questions Cloud

How far away from the battleship is the submarine : A battleship is using sonar (reflected underwater sound signals) to detect the presence of nearby submarines. How far away from the battleship is the submarine
Determine the bounce angle and the group velocity v : Light of free-space wavelenth lambda_0= 0.87 micrometers is guided by a thin planar film of width d=2 micrometers and refractive index n_1=1.6 surrounded by a medium of refractive index n_2=1.4.
Determine the value of the resistance of r : discharge a capacitor of 1mF charged with a voltage of 1 volt we connect it, at time t = 0, with a esistor of R ohm. When we measure the voltage we find it to be V(r) (t) = e ^(-t) u(t). Determine the resistance of R. If the capacitor has a capaci..
Determine what voltage value will be measured : We can model the human body as a voltage source in series with a high resistance, let's say 10mV in series with 100kOhms. If we use an instrument with 1MOhm input resistance, what voltage value will we measure
What is the value of trying new things : Explain how this was a new experience for you - Describe in detail your experience. Where did you go? What did you do? Who else went with you or who did you meet
Write a brief explanation of what the program did wrong : Document your test plan in a table. For each test case, document the expected program behavior and the actual program behavior. If the program does not behave according to your prediction, write a brief explanation of what the program did wrong.
What is the change in volume of the sphere : A solid lead sphere of volume 0.40m^3, dropped in the ocean, sinks to a depth of2.0*10^3 (about 1 mile), What is the change in volume of the sphere

Reviews

Write a Review

Electrical Engineering Questions & Answers

  How is crude oil formed

1.How is crude oil formed ?How is it found/discovered ? 2.How is natural gas formed? (Start with plankton) and include crude oil formation.

  Determine free electron and hole concentration

(a) Determine free electron and hole concentration.(b) Calculate the effective density of states at valence band, Nv. Given that ni = 1x1010 cm3 and kT = 0.026.

  What is the maximum frequency for an input

An OpAMP has a unity gain frequency (ft) of 10MHz and a slew rate of 10V/us and AVoc = 120dB at DC (f=0).Assume VCC = -VEE = 15 Volts. a. Approximate the cutoff frequency of the OPAMP itself.

  Determine synchronous speed and number of stator poles

A 100 hp, 3 phase induction motor, operating at the rated load, runs at 423 rpm when connected across a 450 V, 60Hz supply. The slip at this load is 0.06. Determine A). Synchronous Speed B). Number of stator poles

  Find value of w0 for which amplitude of current is max

Compute i2(t) through resist R, Find value of w0 for which the amplitude of the current |I2| is maximum, compute I2 for w=w0. Does I2 depend on R is there a contradiction with ohm's law

  What is the ratio of the intrinsic carrier concentrations

Semiconductor A has a bandgap of 2.5eV while semiconductor B has a bandgap of 1.5eV. What is the ratio of the intrinsic carrier concentrations in the two materials (niA/niB) at 300K

  What precentage of sound energy is reflected

If the accoustic impedance of water is 1.49 and for steel is 42.1, what precentage of sound energy is reflected at a water-to-steel interface? 12.5%,86.8%,43.9% or 43.59%.

  What is the angle of refraction outside the fiber

Light Traveling an optical fiber (n=1.44) reaches the end of the fiber and exists into air. Answer the following questions: a. if the angle of incidence on the end of the fiber is 25 degress, what is the angle of refraction outside the fiber

  Determine the output voltage assuming the load is infinite

A 10kO potentiometer sensor is used to measure displacement and is connected to a voltage source of 5V. The full range of the displacement is 10mm. When the potentiometer is at 4mm of its maximum displacement.

  Calculate the signal to noise ratio of rms noise voltage

Calculate the signal to noise ratio given RMS Noise Voltage = 20mV and RMS Signal Voltage = 2.5V Calculate ETotalRMS given e21RMS = 5V and e22RMS = 7V

  What command in autocad can be a time-saver

The command in AutoCAD can be a time-saver, particularly when you're working in an application where you want to move a door or windows within walls on a drawing and don't want to redraw the walls.

  How effect do internal capacitances in the transistor model

What effect do internal capacitances in the transistor model have on practical performance of a real system? How would you use these model values to predict system performance?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd