Determine what is the volume of the lake in cubic feet

Assignment Help Civil Engineering
Reference no: EM13317889

A shallow lake can be considered a CFSTR. Nitrification, the conversion of ammonia to nitrate (NH3 -> NO3-) occurs in the lake according to first - order kinetics. One stream feeds the lake and one stream empties the lake with the flow rate in both being 8 cfs. If the first - order decay coefficient is 0.02 day-1, the influent ammonia concentration is 3.5 mg/L and effluent ammonia concentration is 0.25 mg/L, what is the volume of the lake in cubic feet?

Reference no: EM13317889

Questions Cloud

Estimate the net outward force on a passengers eardrum : An airplane takes off at sea level and climbs to a height of 480 m. Estimate the net outward force on a passenger's eardrum assuming the density of air is approximately constant
What is the first order decay coefficient in day-1 : A tank operated as a CFSTR used to remove benzene from a flow stream is 1500 m3 in size. The flow rate in and out of the tank is 8 m3/day. If the influent benzene concentration of 265 ug/L and the effluent concentration is 12 ug/L
Prepare the cad drawings : Need to prepare the CAD drawings
How much work is done by the tension in the cable : A rescue helicopter lifts a 60 kg person straight up by means of a cable. The person has an upward acceleration of 0.70 m/s2, How much work is done by the tension in the cable
Determine what is the volume of the lake in cubic feet : Nitrification, the conversion of ammonia to nitrate (NH3 -> NO3-) occurs in the lake according to first - order kinetics. One stream feeds the lake and one stream empties the lake with the flow rate in both being 8 cfs
What is the flow speed in the narrower section : An ideal fluid flows at 12 m/s in a horizontal pipe. If the pipe narrows to half its original radius, what is the flow speed in the narrower section
Calculate what should the sample volume be : The dissolved oxygen of sample water is 1.5 mg/L. At 25 C, the dissolved oxygen of the dilution water is 8.25 mg/L. You are told the BOD5 of the sample is 130 mg/L. You have a target final dissolved oxygen of 3.0 mg/L
What will the ammonia concentration be 10 miles downstream : The concentration of ammonia is 6 mg/L at one point in the river. If the first - order decay coefficient for the conversion of ammonia to nitrate is 0.05 day-1, what will the ammonia concentration be 10 miles downstream.
Approximate the change in length of the cable : When loaded, the beam carries a 10-kN/m uniformly distributed load. Neglecting the weight of the cable, approximate the following: (a) The change in length of the cable when the beam is under load

Reviews

Write a Review

Civil Engineering Questions & Answers

  Compute the do and initial ultimate bod after mixing

The treated wastewater has a BOD of 12 mg/L and a k of 0.0338 1/d. The Broad River has a flow rate of 0.43 m3/s and an ultimate BOD of 5.0 mg/L.

  Compare the total reactor volume required for removal

Compare the total reactor volume required for 90% removal of a substance that decays according to first-order kinetics with a rate constant of 0.05 day -1 in a CM system that contains a single reactor against a system that contains three CM reacto..

  Determine the depth of flow in the channel y2

Water flows down a spillway at the rate q = 15 m^3/s into a horizontal channel where v1 = 20 m/s. Determine the depth of flow in the channel y2 that will casue the hydraulic jump to occur in the channel. Determine the headloss hL in the jump.

  Determine the total crop water requirement

Determine the total crop water requirement including the leaching ratio of a corn crop with a ECt of 1.7mmhos cm-1 if the ECiw of the irrigation water and precipitation is 5 and 0 mmhos cm-1 respectively

  Determine what is the maximum daily mass of chloride

The pipe has a flow of 5 m3/s. The stream's chloride concentration just upstream of the pipe's dischage is 12 mg/L, and the runoff pipe's discharge has a chloride concentration of 40 mg/L. Chloride is a conservative substance.

  Compute required weight of coarse aggregate per cubic yard

A concrete mix with a 3-inch slump, w/c ratio of 0.50, and sand with a fineness modulus of 2.4 contains 1700 lb/yd^3 of coarse aggregate. Compute the required weight of coarse aggregate per cubic yard.

  What is the design storage and water surface elevation

What is the design storage and water surface elevation at the peak outflow rate and estimate the long-term average reduction (EPA, 1986) in particulates under dynamic conditions.

  Determine the produce of inertia for the shaded area

Determine the produce of Inertia, Ixy, for the shaded area to the right using integration. Use the parallel axis theorem to find Ibarxy, the product of inertia with respect to the centroidal axes.

  Define need before function

Which of the following is not a basic systems engineering concept?a. Define need before function

  For what flowrate through the venturi meter will cavitation

for what flowrate through the Venturi meter will cavitation begin if p1=275 kPa gage, atmospheric pressure is 101 kPa (abs) and the vapor pressure is 3,6 kPa (abs)

  Discuss role that believed surety would play in firms role

The New Jersey Surety Association, in various documented publications discusses the Surety's relationship with their clients, the best ways to better know your Surety and a brief overview of why the Construction Business can fail.

  Find power rating of electric heater required to maintain

A room 7m x 6m x 3m high is to be electically heated to maintain the inside temperature at 20 C, when it is 0 C outside. The room has 2 windows each 1.2m x 1.8m and a sliding glass door 2.4m x 2.1m.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd