Determine what is the transmission angle

Assignment Help Electrical Engineering
Reference no: EM13226838

A 5 GHz parallel polarized wave with amplitude 5 V/m is oblique incident from an air of (z<0) into a lossless magnetic material with 

\(\epsilon_{r} = 9\)

when z>0. The angle of incidence is 53.13 deg.

What is the transmission angle?

Find K (incident), K (reflective) and K (transmission)?

What is the incident electric field in time domain?

What are the transmitted E and H fields?

Reference no: EM13226838

Questions Cloud

Calculate the voltage at the transmitting end : A 60-Hz, single-phase transmission line has a length of 80 miles. Its shunt conductance (G) is 3.4×10?11 S/mile, resistance (R) is 0.1 ?/mile, capacitance (C) is 16 pF/mile, and inductance (L) is 0.56 mH/mile.
Specify the value of a smaller inductance : A single-phase, 60-Hz power will be transmitted through the transmission line Each subconductor's radius is 10 cm. There are two configurations, the first one is setting subconductors A and B as a bundle, and C and D as another bundle
Determine what is the frequency of oscillation : For a Wien-bridge oscillator Given R = 20Kohm and C = 10nF what is the frequency of oscillation Given a required frequency of oscillation of f = 3kHz and R = 5kohm, what should the value of C be
Calculate the power converted to mechanical power : A 480 V permanent magnet ac motor is consuming 10 kW at power factor 0.80 lagging. Its speed is 1800 rpm. The winding resistance is 0.5 ohms per phase. Core losses are 100 W. Mechanical losses are 250 W. Stray losses are 1.5% of the input power
Determine what is the transmission angle : A 5 GHz parallel polarized wave with amplitude 5 V/m is oblique incident from an air of (z 0. The angle of incidence is 53.13 deg. What is the transmission angle
Calculate the current at the transmitting end : A) If 220kV, 220 MVA with power factor 0.8 lagging is determined to be at the receiving end, calculate the voltage at the transmitting end. B) If 220kV, 220 MVA with power factor 0.8 lagging is determined to be at the receiving end
Calculate the unit impulse and the unit step responses : A simple low-pass discrete-time filter is characterized by the following linear difference equation: y[n] = f y[n-1] +(1- f) x[n] , with 0  1 Draw and clearly label an adder-gain-delay diagram for the filter. using the same difference equation from a..
At what time t2 has 50 percent of the initial energy stored : A 190-F capacitance is initially charged to 1190V . At t = 0, it is connected to a 1-k resistance.  a) At what time t2 has 50 percent of the initial energy stored in the capacitance been dissipated in the resistance
Calculate the inductive reactance per meter : Calculate the inductive reactance per meter of a single-phase, 50-Hz, two-wire transmission line. Assume each conductor's radius is 6cm and the distance between the two conductors is 3m.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is 3db frequency of closed-loop inverting amplifier

Sketch the Bode plot (closed-loop gain vs. frequency, and closed-loop phase vs. frequency) of the amplifier. Label the gains at 0.1*f3dB, f3dB, and 10*f3dB using dB-scale. Also indicate the values of the phases at these frequencies.

  What does the documentation mean

Using the Internet, a magazine, or a provided list of memory modules, determine the exact part numbers and quantities of memory modules that you would buy. List them with the location of where you obtained the information.

  Find the voltage between the points integrating along a line

Given the electric field E=4xux+2yuyV/m find the voltage between the points A(2,0) and B(0,2) integrating along: (a) straight line AB; (b) broken line AOB, where O(0,0).

  Basic neutralizer control system

Write a short report that analyses the P&ID - Basic Neutralizer Control System: The neutralizer process may be used to adjust the pH of a feed stream.

  What is the relative permittivity er of the dielectric

Will the electric field inside change (how much if yes)? Will the stored energy in the capacitor change (how much if yes)?

  Define what is the fm improvement in db

What is the peak frequency deviation of the FM signal? What is the FM improvement in dB?

  Calculate short-circuit current of a three-phase delta-wye

calculate the short-circuit current of a three-phase delta-wye connected transformer if the short circuit occurs between phase A and the neutral at the low voltage side, and the transformer is supplied by a 13 kV line-to-line voltage.

  Write a program to genrate a square wave

assuming XTAL=11.0592 MHz,write a program to genrate a square wave of 20 Hz frequency on pin2.3?

  Find the parameters of the z-parameter two-port

The following measurement were made on a two-port resistive circuit. With port 1 open, V2 =15V, V1 = 10 V, and I2 = 30 A. With port 1 short-circuited, V2 = 10 V, I2 =4 A, and I1 = -5 A. Find the parameters of the z-parameter two-port.

  Dispense requested amount using least number of bills

Dispense requested amount using least number of bills, Write a C program for an automatic teller machine that dispenses money. The user should enter the amount desired (a multiple of 10 dollars)

  Compute the voltage indicated

resistor: a volt-ohmmeter with an internal impedance of 1000 Ω/V and an EVM with an impedance of 11 MΩ. Calculate the voltage indicated by each of these devices.

  Design circuit using only two-three and four-input nand gate

Design a circuit that will add either 1 or 2 to a 4-bit binary number N. Let the inputs N3, N2, N1, N0 represent N. The input K is a control signal. The circuit should have outputs M3, M2, M1, M0, which represent the 4-bit binary number M.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd