Determine what is the switching loss in the transistor

Assignment Help Electrical Engineering
Reference no: EM13256027

A boost converter has 5 V input and 12 V output at 60 W. The diode is ideal. The transistor requires 1 uS to turn on or off. The switching frequency is 100 kHz. The storage components are large.

a) Plot the current and voltage waveforms associated with the transistor? (Hint: KVL and KCL must be satisfied, and an ideal diode carries current only when it is on)

b) What is the switching loss in the transistor?

Reference no: EM13256027

Questions Cloud

What is the tension in the cable closer to the painter : A scaffold of mass 44 kg and length 6.0 m is supported in a horizontal position by a vertical cable at each end. What is the tension in the cable closer to the painter
Display a chemical equation for the reaction : Write a chemical equation for the reaction of an aqueous solution of sodium stearate with each of the following
What is the maximum load possible without a heat sink : A small buck converter has 24 V input and 12 V output. The transistot has Rds(on) = 0.1 Ohms. The diode is modelled as a 1 V drop. Each device has Rtheta(ja) = 40 K/W and Tjucntion
Why you think this system is best for consumers : Explain which economic system (market, planned, mixed, or traditional) you think is best for consumers. Describe at least one reason why you think this system is best for consumers.
Determine what is the switching loss in the transistor : A boost converter has 5 V input and 12 V output at 60 W. The diode is ideal. The transistor requires 1 uS to turn on or off. The switching frequency is 100 kHz. The storage components are large.
Determine the rms voltage across the inductor : An 84.4-mH inductor and a 6.27-µF capacitor are connected in series with a generator whose frequency is 361 Hz. Determine the rms voltage across the inductor
What tables might you use from the compound interest charts : What factors would you consider in making your finacial evaluation? What tables might you use from the Compound Interest charts and why?
The ph difference across the membrane of a glass electrode : The pH difference across the membrane of a glass electrode is 6.45. How much voltage is generated by the pH gradient at:25degreesC and 40 degreesC
Build lamp logic for a stationary bicycle exhibit at museum : As speed increases, the lower lamp, L1 lights, then L1 and L2, then, L1, L2, and L3, until all lamps light at the highest speed. Once all the lamps illuminate, no further increase in speed will have any effect on the display.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  How many volts must be applied to a 3- ohm resistor

How many volts must be applied to a 3- ohm resistor to result in a power dissipation of 752W 3) A 0.27-k ohm resistor is rated 2W. Compute the maximum voltage that can be applied and the maximum current that it can carry without exceeding it..

  Determine which frequencies will be the aliased one

a) Plot the spectrums for the range from 0 Hz to 25000 Hz. Make sure to label the frequncies. b) sketch the recoverd analog signal spectrum if an ideal lowpass filter with a cutoff frequncey of 4.5 kHzis used to filter the sampled signal.

  Calculate the output voltage vo of operational amplifier

Consider the circuit as shown below. If Vin peak voltage = 12V, Calculate the output voltage Vo. Open loop voltage gain of the Operational Amplifier A=10,000. The voltage drop across the diode is 0.7 V.

  What is the saturation current and surface leakage current

A silicon diode has a reverse current of 5 uA and 25 degrees celcius and 100uA at 100 degrees celcius. What is the saturation current and surface leakage current at 25 degrees celcius

  How is the tcnt timer used to generate an interrupt

1.The S12G128 CPU board has one IRQ pin. You have four devices that will request interrupt service. How do you determine which device(s) need service 3.A communications channel has a bandwidth of 2,000 Hz and a signal-to-noise ratio (SNR) of 40 dB.

  What does tp become if the design is changed to matched one

Find the propagation delay for a minimum-size inverter for which Kn' = 3 Kp' = 180 uA/V^2 , and (W/L)n = (W/L)p = 0.75 um/0.5 um , VDD = 3.3 V , Vtn = -Vtp = 0.7 V, and the capacitance is roughly 2

  What is the frequency for a periodic signal with a period

What is the frequency for a periodic signal with a period of 2.5 ns 2.5 GHz 250 MHz 4.0 GHZ 400 MHz 2. Which decimal number is equivalent to 25 10 25 31 32 3. Convert the following decimal negative numbers to their 8-bit, 2's complement formulatio..

  Find the line parameters

A transmission line operating at 125 MHz has Zo = 40 Ω, α = 0.02 (Np/rn), and ß = 0.75 rad/m. Find the line parameters R', L', C', and G'.

  Determine peak current during the discharge of capacitance

A person shuffling across a dry carpet can be approximately modeled as a charged100-pF capacitance with one end grounded. If the person touches a grounded metallic object such as a water faucet.

  How the jfet will be operating in the saturation region

Design the circuit  so that the voltage at the gate is -12V, the drain current ID is 1 mA, and the drain to source voltage VDS is 4.7V. The JFET must be operating in the saturation region. Use standard 5% tolerance resistors.

  What is the range of no-load voltage vt as r adj

The magnetization graph taken at 1800 rpm of a 6 kW, 120 V, 50 A, 1800 rpm, dc generator is attached below. Field resistance is 20 ohms and armature resistance is .18 ohms. Find: As a seperately excited generator

  Is there enough voltage resolution to not require added gain

The bandwidth of interest is between 0.5 and 50 Hz and has peak amplitude of approximately +/-1 mV. -a. Design and draw a block diagram (not circuit) of the signal conditioning portions (everything before ADC) of your system.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd