Determine what is the converter efficiency

Assignment Help Electrical Engineering
Reference no: EM13256503

a boost converter operates at 20 khz, and converts power from a solar panel to a battery bus. the panel has norminal volate of 16v and current up to 3 A. the battery bus is 48 v. the transistor can be modelled as a 0.5 v constant forward drop. while diode is a 1.0 v drop, which device dissipates more power? what is the converter efficiency?

Reference no: EM13256503

Questions Cloud

Find what is the highest possible output voltage magnitude : ts diode acts as a constant 1.0 V drop. the input voltage is 12.0 V. tje ;pad os a 4 ohm resistor. what is the highest possible output voltage magnitude, and at what value duty ratio does it occur
Prepare an income statement-instockholders equity : Prepare an income statement, statement of changes instockholders' equity, balance sheet, and statement of cashflows
What is the volume of the material : A sample of an unknown material appears to weigh 255 N in air and 195 N when immersed in alcohol of specific gravity 0.700. What is the volume of the material
How can the u.s. stop going further in debt : why would one want to se a rent to own store for mechandise ? think of at least three reason and record them below.
Determine what is the converter efficiency : a boost converter operates at 20 khz, and converts power from a solar panel to a battery bus. the panel has norminal volate of 16v and current up to 3 A. the battery bus is 48 v. the transistor can be modelled as a 0.5 v constant forward drop.
What would be the consequence of that recruiting strategy : Suppose that an employer has a close working relationship with your college and primarily recruits from there for professional positions. What would be the consequence of that recruiting strategy? Would it tend to result in adverse impact?
Evaluate kc and kp for the reaction : The emerging gas is collected in a 5.00L flask and is found to contain 8.62g of carbon monoxide, 2.60g of hydrogen gas, 43.0g of methane, and 48.4g of water vapor. Assuming that equilibrium has been reached, calculate Kc and Kp for the reaction.
Economic order quantity-optimal order quantity : What is the economic order quantity? What would be the optimal order quantity if the carrying cost were cut in half to Rs. 0.05 a filter per month?
Write the journal entries for the transaction : On December 31, 2007, BradstormCompany had 1,500,000 shares of $10 par common stock issued and outstanding. Write out the journal entries for these transaction.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Can rectification be obtained with an ohmic contact

Is the high carrier concentration in transparent conductors due to their ideal band structure or to the presence of defects and dopants. If two different materials but with the same work function are brought into contact, does band bending result.

  What speed will the spacecraft crash into lunar surface

To the dismay of scientists on earth, an electrical fault causes an on-board thruster to fire, decreasing the speed of the spacecraft by 26.0m/s .If nothing is done to correct its orbit

  Determine what is the phase current of the load

A balanced Y-connected power system is known to have Van=100

  Find what is significant about the dc voltage measurements

Construct the RC differentiator. Set the channel 1 input coupling switch to dc. Next adjust the dc offset, amplitude, and frequency controls of the function generator to produce the input waveform.

  Design appropriate amplifier needed to maintain the signal

the hd cable signal send out is usually ranging between (1-25mv), with the frequency range from 1000Hz- 20Khz. An amplifier will gain 46 db will boost the signal before sending it through the cable connection.

  What is the phase angle between the line current

Assume the motor is connected in wyne and that each branch can be represented by a resistance R in series with an inductive reactance X. (a) Calculate the value of R and X. (b) What is the phase angle between the line current

  Find the maximum signal energy and design a demodulator

Suppose we transmitted 5 cos wct for logic one and 15 cos wct for logic zero. Find the maximum signal energy. Design a demodulator and show the detection criterion for the output of the demodulator. Finally, find the bit error-rate.

  How effect do internal capacitances in the transistor model

What effect do internal capacitances in the transistor model have on practical performance of a real system? How would you use these model values to predict system performance?

  Explain what is the input impedance

If we have a 600ohm transmission line terminated with a 1200ohm resistor, how long must the transmission line be if the input impedance is purely real?

  Explain what will the new mean and variance

Maximum Likelihood to get the above parameters i.e. u0 and var. Now from these 999 points, I take one point out (lets call it i) and add a new point (lets call it j). What will the new mean and variance be?

  Design a circuit to multiply a 2-bit unsigned magnitude

Design a circuit to multiply a 2-bit unsigned magnitude binary number by 1, 2, 3, or 4 to produce a 4-bit output

  Calculate the l and c values of an l network

Calculate the L and C values of an L network that is to match a 9 ohm transistor power amplifier to a 75 ohm antenna at 122 MHZ.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd