Determine what is the acceleration of diatomic oxygen gas

Reference no: EM13315198

2 kilomoles of diatomic oxygen gas are enclosed in a 10-kg steel container. A force of 2kN now accelerates this system. What is the acceleration?

Reference no: EM13315198

Questions Cloud

Determine the mass of neon in a vertical cylinder : Neon gas at 50 degrees C in a vertical cylinder of diameter 150 mm has a 6 kg frictionless piston mounted. The outside pressure is 98kPa and the neon volume is 4000cm^3. Find the mass of neon.

Find the tension in the string an instant before it broke : A 300g ball on a 70cm -long string is swung in a vertical circle about a point 200 cm above the floor, What was the tension in the string an instant before it broke

Find the piston mass that will create a pressure inside : A vertical hydraulic cylinder has a 150-mm diatomic piston with hydraulic fluid inside the cylinder and an ambient pressure of 1 bar. Assuming standard gravity, find the piston mass that will create a pressure inside of 1250kPa.

What is the final speed of the block : A small block of mass 0.97 kg slides without friction on a horizontal table. Initially it moves in a circle of radius R0 = 0.52 m with a speed 1.3 m/s. What is the final speed of the block

Determine what is the acceleration of diatomic oxygen gas : 2 kilomoles of diatomic oxygen gas are enclosed in a 10-kg steel container. A force of 2kN now accelerates this system. What is the acceleration

What does the slope of the linear line : A graph of the Force applied to a spring and the distance it stretches F vs. x yields some valuable information. What does the slope of the linear line

Calculate what is the force required at a constant rate : A 20-kg iron ball is moving at 100 km/hr should be accelerated at a constant rate of 10 m/(sec)^2. What is the force required

Hat is the direction of the net electrical field : Consider two particles, each with a charge of +Q located at the opposite corners of a square of side d. What is the direction of the net electrical field at point P

Determine the average normal stress at the critical section : two 10 mm thick steel plates are fastened together by means of two 20mm bolts that fit tightly into the holes. if the joint transmits a tensile force of 45 kn determine the average normal stress in the plates at a section where no holes occur

User Account

All Pages