Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A 2N3904 has a power dissipation of 625mW without a heat sink. If the ambient temperature is 65 degree C, what happens to the power rating?
We need to use asynchronous TDM and combine 50 digital sources. On average only 20% of the sources are active at any time. Each output slot carries 18 bits of data from each digital source. Also 8 extra bits are added to each frame for synchroniza..
Analysing spectrum anlyser output, A spectrum analyzer is connected to an unknown signal. The spectrum analyzer displays the power level of signals in dBm vertically and frequency horizontally. The spectrum of the unknown signal creates the follow..
Describe the steps in the keypad polling routine. Draw a flow chart for the keypad LCD software code. Discuss challenges experienced in developing the keypad LCD software code.
The steering wheel of a car has a radius of 0.11 m, while the steering wheel of a truck has a radius of 0.28 m. The same force is applied in the same direction to each. What is the ratio of the torque produced by this force
How tall must the antennas be if the link operates on a frequency of 2.450Ghz, D1=5miles, D2=11miles, and the obstruction is 60 feet high?
2. What is the expected output frequency of a sample and hold system if fs= finput 3. Which is input frequencies will give an output frequency of 50 Hz when put through a sample and hold system if our sampling frequency is 488 Hz
Ted Williams hits a baseball with an initial velocity of 120 miles per hour (176 ft/s) at an angle of f = 35 degrees to the horizontal. The ball is struck 3 feet above home plate. You watch as the ball goes over the outfield wall 420 feet away
What is the symbol rate and what is the bandwidth occupied by the 16-QAM signal? The link must maintain a BER no higher than 10^-6. What is the minimum CNR in the receiver to meet this requirement?
1. A MOD 8 down-counter is holding the count 101 (base-2). What will the cound be after seven clock pulses 2. A MOD 5 and a MOD 20 counter are cascaded. What is the output frequency if the input frequency is 60MHz
What are the techniques used to make feedback system stable? Explain and draw the frequency response of a 1-pole feedback amplifier.
An OpAMP has a unity gain frequency (ft) of 10MHz and a slew rate of 10V/us and AVoc = 120dB at DC (f=0).Assume VCC = -VEE = 15 Volts. a. Approximate the cutoff frequency of the OPAMP itself.
A certain lightbulb has a tungsten filament with a resistance of 21.9 when at 20.0°C and 145 when hot. Assume the resistivity of tungsten varies linearly with temperature even over the large temperature range involved here.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd