Determine what flow rate are required from the local well

Assignment Help Civil Engineering
Reference no: EM13323185

a town requiring 2 cms ofwater has two sources, a local well with 15 g/m^3 of a contaminantand a distant surface water source with 2 g/m^3 of the contaminant. form the SDWA the contaminant can not be present at concenterationabove 5 g/m^3. what flow rate are required from the local well andthe surface water?

Reference no: EM13323185

Questions Cloud

Determine the smallest wall thickness which may be used : A spherical pressurevessel of 1.2m outside diameter is to be fabricated from a steelhaving an ultimate stress of σU450 MPa. Knowing that a factor of safetyof 4.0 is desired and that the gage pressure may reach 3 MPa,
Write a program that takes its input from a binary file : The number a is the average of the numbers n1, n2, n3, and so forth. Hint: Write your program so that it first reads the entire file and computes the average of all the numbers, then closes the file, and then reopens the file and computes the stan..
Determine normalstress in basketball of 12 inches diameter : Determine the normalstress in a basketball of 12 inches diameter and 0.1 inch wall thickness which has been inflated to a gage pressure of 15psi.
What is the atomic number : An atom is ionized so that it has only one electron. When the electron drops from the n = 4 shell to the n = 1 shell, What is the atomic number
Determine what flow rate are required from the local well : a town requiring 2 cms ofwater has two sources, a local well with 15 g/m^3 of a contaminantand a distant surface water source with 2 g/m^3 of the contaminant.
What is the width of the slit : A helium-neon laser (wavelength=666 nm) illuminates a single slit and is observed on a screen 1.5 m behind the slit. What is the width (in mm) of the slit
Describe the difference between tightly coupled and loosely : Describe the difference between tightly coupled and loosely coupled systems and give an example of the types of applications that can be run on each of the systems.
Explain how to promote selling the property : HJ Heinz Corporation is constructing a distribution facilityin Italy for products such as Heinz Ketchup, Jack Daniel's Sauces,HP steak sauce, and Lea & Perrins Worcestershire sauce. A15-year life is expected for the structure.
How does the use of interrupts increase the efficiency : How does the use of interrupts increase the efficiency of a computer while executing programs.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Estimate how long it will take before the daily maximum

Estimate the steady state PM10 concentration assuming a PM10 deposition velocity of 0.12 cm/s, prevailing wind velocity of 2.5 m/s, and a constant emission flux of PM10 0.82 mg/m2-s.

  Find the resultant couple moment acting on the beam

(a). Find the sum of moments about point E due to this system of forces (b). Find the sum of moments about point A due to this system of forces (c). Find the resultant couple moment acting on the beam

  Determine the flow rate of water through the channel

The flow rate of water flowing in a 3m wide channel is to be measured with a sharp-crested triangular weir 0.5m above the channel bottom with a notch angle of 60°. If the flow depth upstream from the weir is 1.5m

  Find how many trucks are needed to service the backhoe

A haul fleet of trucks having a heaped capacity of 15 cy. is to be loaded by a hydraulic backhoe excavator (CT=.48 min.) with a 3 1/2 cy. heaped capacity. Assume the material is a wet loam that weighs 3380 lb/cy in the bank state

  Find the amount of work in foot-pounds required to empty

The vertical cross-section of the trough parallel to an end is shaped like the graph of y=x6 from x=-1 to x=1 . The trough is full of water. Find the amount of work in foot-pounds required to empty the trough by pumping the water over the top.

  Determine the concentration in weight percent of v

Iron and vanadium both have the BCC crystal structure, and V forms a substitutional solid structure in Fe for concentrations up to approximately 20 wt% V at room temperature.

  Calculate max bending stress and shear stress in the pole

A Timber power-line pole is 10 in. in diameter at its base where it is solidly embedded in concrete. The pole extends 20 ft vertically upward from its base and is subjected to a horizontal pull of 300 lb at its top.

  What bolt sizes must be used for the allowable shear stress

A structural steel beam is attached to a column with bolts. The downward force on the connection is 150 kips. What bolt sizes must be used if the allowable shear stress is 25.0 ksi

  What is the length of a 2 degree increment along meridian

What is the length of a 2 degree increment along a (A) meridian and (B) parallel at 45N and 115W. Assume the radius of Earth is 6370 km.

  Calculating the relative compaction of a dam project

A dam project specifies 97% compaction. Lab tests on the soil being used indicate that it has a maximum dry density of 1900 kg/m 3 at an optimum water content of 13.2%.

  How the extent of martensite formation may be increased

Name the three factors that influence the degree to which martensite is formed throughout the cross section of a steel specimen. For each, tell how the extent of martensite formation may be increased.

  Calculate fiber weight fraction for unidirectional carbon

For unidirectional carbon/epoxy tape at a 60% fiber volume fraction, calculate E11 and E22. Given Ef= 211 GPa and Em =10 GPa. Calculate the fiber weight fraction. Given pf=1.95 g/cm3 and pm =1.3 g/cm3.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd