Determine the zin if the lines are 0.5 m long

Assignment Help Electrical Engineering
Reference no: EM13230248

A lossless line having an air dielectric has a characteristic impedance of 100 Ohms. Another line that is identical in dimensions to the air line is fabricated with the air displaced by a dielectric material have an \(\epsilon_{r}\) value of 4. Both lines operate at 200 MHz and ZL = 200 %u2013 j100 . For each line use the applicable equations to find: (a) s (the standing wave ratio) and (b) Zin, if the lines are 0.5 m long.

Reference no: EM13230248

Questions Cloud

Nitric acid is not only a strong acid also a oxidizing agent : Nitric acid is not only a strong acid but also a strong oxidizing agent. In hot concentrated acid solution, the reaction with zinc is: 3 Zn(s) + 8 HNO3 ? 3 Zn(NO3)2(aq) + 2 NO(g) + 4 H2O
Discuss the different approaches to globalization strategies : 1) How does corporate strategy differ from business strategy. Give me an example of each. 2) What are the "ups and downs" of a growth strategy? 3) Discuss the different approaches to globalization strategies.
Determine the dynamic behavior of the tank concentrations : Determine the dynamic behavior of the tank concentrations (CA0 and CA) in response to a step change in inlet concentration by 0.925 mole/m3. Estimate the time it takes until 63% of the change in outlet concentration, CA has occurred.
What is the impact of leveling within slack on sensitivity : What is the impact of leveling within slack on the sensitivity of the network?
Determine the zin if the lines are 0.5 m long : A lossless line having an air dielectric has a characteristic impedance of 100 Ohms. Another line that is identical in dimensions to the air line is fabricated with the air displaced by a dielectric material have an \(\epsilon_{r}\) value of 4.
Calculate the seasonal index for july : A seasonal index for a monthly series is about to be calculated on the basis of the past four years' accumulation of data. the four previous July values were 110, 135, 125, and 130. The four previous total year values were 1440, 1920, 2400, and 19..
What approaches can be taken to develop a supply chain : What approaches can be taken to develop a supply chain infrastructure that provide an accurate view of overall channel performance?
What is the velocity of propagation in the cable : A certain transmission line is 10 meters long. Measurements indicate that the total inductance of the cable is 16 uH. Standing wave measurements indicate that the voltage reflection coefficient at the load is 0.5 + j0
Explain what is the concentration ratio of the free toxic : what is the concentration ratio of the free (and potentially toxic) Pb^2+(aq) in the blood to the much less toxic Pb^2+ -EDTA complex?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  How many turns are required for a circular loop

How many turns are required for a circular loop of 100-mm radius to develop a peak emf of 10mV if the loop rotates 30r/s in the earth's magnetic field Take B = 60E-6T.

  How many bits to the left of binary point represent number

What fixed point unsigned representation, with how many bits and how many bits to the left of the binary point, should we use if we need to represent numbers in the range 0 - 100 with a resolution of .001 or better

  What are ethical challenges and issues with technology

There are a number of factors and precautions that need to be considered when developing and introducing new technologies to the marketplace. This is especially the case when this could be a technology without a sustainable known history.

  Electrical and instrumentation use

Electrical & Instrumentation Use, State typical values for the loading effect on a low voltage AC circuit containing a lamp when measuring current with

  What is the range of the sensor voltage outputs initially

a. What is the range of the sensor voltage outputs initially and finally? b. What range of voltages would be expected to be measured 2 sec after the step change is applied?

  Find out the voltage level required

A microwave system requires a +4-dBm audio level to provide 100% modulation. Determine the voltage level required if this is a 600 ohm audio system.

  Give empirical equations relating saturation temperature

Make a table showing Temperature as a function of pressure for Psat from 20 to 600 psia every 20 psi, and another table showing pressure as a function of temperature from 150 degrees to 350 degrees every 20 degrees.

  What is apples approximate die cost

Apple A5 die size is 122mm^2 when fabricated in 45nm technology. Assume they purchase 300mm wafers at a foundry for $ 2.5K /wafer. Assume a yield of 70%. What is Apple's approximate die cost?

  Calculate the pressure in point 1 and the density

A U manometer reads 20 cm air as operating fluid and a given manometric fluid. A single branch closed tube reads 35 cm connected to point 1. If P2 = 1.2 ATM calculate the pressure in point 1 and the density of the manometric fluid.

  Define a digital signaling system is required to operate

A digital signaling system is required to operate at 9600 bps. If a signaling element encodes a 8-bit word, what is the minimum required bandwidth of the channel?

  At what frequency is impedance a minimum

A series-resonant RLC circuit has R = 80 (ohms), L=25mh, and C=10pF. A) Sketch and label the circuit. B) Find fo, the resonant frequency. C) At what frequency is impedance a minimum D) What is the magnitude of the impedance at this frequency

  Write a matlab program to compute the capacity

Write a MATLAB program to compute the capacity of an AWGNC with a given bandwidth and for equally spaced values of between and including and (in dB).

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd